Configuration & Commissioning Alarm BSC Box

8/10/2019 Configuration & Commissioning Alarm BSC Box

1/24

Configuration & commissioningAlarm BSC box

WAGO alarm BSC box with double Ethernet ( X1 & X2 )


2/24

To commissioned any version from alarm BSC box ,must know below diagram well

OMC BSC Evo Alarm BSC box

TELECOM Switch Router

Workas

Workas

Workas


3/24

1. Connect to BSC to get some IPs that willuse in commissioned alarm BOX

A) Connect to BSC as below snapshots

- Put IPs Local area connection as below


4/24

- Then open Windows 9130 BSC terminal and Put below IP address

OK to be connect on BSC


5/24

- To be master on BSC take any action locally press F6 and F5 to view Full report

parallel as below


6/24

B) Now after connect , needed to get BSC IP address that OMC can see BSC from it and r

BSC IP addressas below

-- Commands >> BSS Operations >> Display IP Parameters


7/24

-- Press OK


8/24

-- Double click or press ENTER on DIS IP PARAMETERS to view this reports


9/24

-- appear window with multi. Tabs , select IP Parameters Page 1 Ta


10/24

-- from this Tab , we can get real BSC IP addressas 10.58.69


11/24

-- To get BSC IP address that OMC can see BSC from it , follow below slides

Commands >> BSS Operations >> Display BSC Peer Entities


12/24

-- Double click or press ENTER on DIS IP ENTITIES to view this rep


13/24

-- from this window , we can get BSC IP address that OMC can see BSC from it as b

Display BSC Peer Entities >> Address -2 >> BSC NTP IP Address as 10.57.216.12


14/24

-- Now , we get below IPs from BSC that will use in commission alarm BSC box

1) BSC IP address that OMC can see BSC from it as 10.57.216.12

2) Real BSC IP address as 10.58.69.49

Note : OMC can see BSC from two IP ( 1 0r 2 ) depend on early creation and in this case was (


15/24

2. Commissioned Alarm BSC box

A) Connect to Alarm BSC box via Ethernet cable on X1

-- Put Local area connection IPs as below


16/24

-- in any URL page put 192.168.1.1 to open Main page for WAGO


17/24

-- Select TCP/IP tab from left corner , needed username & Password put it as below

Username : adminPassword : wago


18/24

-- in TCP/IP tab

** Put IP address as 10.58.69.54 that mean +5 from real BSC IP address as BSC keep this IPfor Alarm BOX

** Put Gateway as 10.58.69.51 that mean +2 from real BSC IP address as BSC keep this IP f

DCN IP

Then SUBMIT to save changes


19/24

-- Then select Ports tab from left corner to configured it , needed username & Passwordit as below

Username : adminPassword : wago


20/24

-- in Ports tab

** Make check / uncheck as below then SUBMIT to save changes


21/24

-- select SNMP tab from left corner

** Put Trap receiver 1 as 10.57.216.12 this IP that OMC from it can see BSC



22/24

-- Select Clock tab from left corner

** adjust Time & date as below



23/24

-- after that Alarm BSC box configured well and its IP changed to be 10.58.69.54 so if y

want to connect it again

** Local area connection must be

** Put in any URL 10.58.69.54 not 192.168.1.1


24/24

With my best wishe

Eng. Ahmed MagdI AhmedMobiserve Egypt / Menya office

Documents

Configuration & Commissioning Alarm BSC Box