Computer Sensor Install: 02/25/09

Parts Needed: -1 computer sensor -2 zip ties -1 “L” bracket (highlighted in yellow) (provided with your computer when you order from TerraTrike) Directions: (PART 1) 1) On the left hand side of the trike, unbolt the tie rod at the hubmount. 2) Without sliding the tie rod off the bolt, slide the L bracket on the bolt. *The L bracket shouldn’t be installed on the top of the tie rod.* 3) With sensor in-hand, install zip ties but don’t tighten them all the way just yet. 4) Remove the white plastic covering the sticky backside of the plastic sensor bracket. 5) Slide the zip ties and the sensor up onto the L bracket. 6) Tighten the zip ties and start to position the L bracket as shown in the picture below. ***THE BELOW PICTURE IS FOR PART 1*** ***THE BELOW PICTURE IS FOR PART 2***

Adjusting the Sensor and L Bracket Mount: At this point, your setup should look similar to the above picture. -The L bracket (highlighted in yellow) can swivel toward or away from the wheel (this is highlighted in red). -The sensor can swivel forward and backward (highlighted in pink) by loosening the fastener (highlighted in blue) located at the top of the plastic sensor bracket. -When you’re finished installing the L bracket, sensor, sensor mount, and wheel magnet, the distance (highlighted in green) from the sensor to the wheel magnet should be at most 3/16” or 4.76mm (if not closer). *Depending on what trike you have, your finished setup might look a little different, but the installation instructions are still the same.* Computer Setup and Calibration: (PART 2) you will need an accessory mount for this next step (you can purchase a mount through your local dealer or www.TerraTrike.com). 1) Press the reset button located on the backside of the computer. 2) Next, use the Mode button on the front of the computer to select “KPM” or “MPH”. Then press the “Menu” button on the backside of the computer. 3) You should now see four numbers with the farthest number to the right blinking. Now, it’s time to calibrate the wheel size. Use the “Mode” button to select the correct numbers. For the 20” TerraTrike wheels you will be entering “1515” as the wheel size. First, you will cycle through the numbers using the “Mode” button until you get to “5”. Then press the “Start/Stop” button. This will confirm the “5” and bump you over one spot to the left. Continue through until the display reads “1515” then press “Menu”. 4) The screen will now display your total ride time and either MPH or KPH (whichever you specified in step two). By pressing “Mode”, you can see different read-outs (time, distance, average speed, etc). 5) Mount the computer to its plastic bracket then zip tie to the left hand side of the accessory mount. *If at anytime you want to recalibrate you computer, simply press the reset button on the back side and follow these step again.* ***There are also instructions that come with the computer that explain setup in greater detail.***