COMPANY PROFILE

Buranga site,guyed tower anchor

Branex Co. Ltd. has multi-annual experience in supplying and installing of telecommunication sites in Europe and Asia and Africa, including supply and installation of: antenna towers, generators, shelters and fences.Branex Co. Ltd. is company registered on Malta with HQ based in the wonderful city Mosta (economic and trade center of Malta).

In our palette of towers we are offering different types of telecommunication and radio steel towers. All towers are shaped and dimensioned to take into account additional loads (wind, ice, snow and equipment weight) to meet all stability and mechanical safety. We have specialized in the complete service of construction of movable communication stations. This includes all necessary construction works, manufacturing and installing of towers and antenna systems.The most common types of steel constructions for telecommunication systems that we are offering are:- mobile towers (heavy duty, middle duty and light duty towers),- lattice towers (heavy duty and middle duty)- guyed towers (middle duty and light duty).- rooftop towers (poles and masts)Also we are providing complete infrastructure for telecommunication site including supply and installation of shelters, fences and generators.Branex Co Ltd is also fully capable for turn-key operations (installation of complete telecommunication site – including RF installation).

BRANEX Co. Ltd.

Foundation of mobile towers requires no civil works because its overturning and sliding stability is achieved by means of adequate ballasts combining the weight of the steel structure with that of the pre-caste concrete foundation.

MOBILE TOWERS

Foundation for mobile towers requires no civil works because it’s overturning and sliding stability is achieved by means of adequate ballasts, combining the weight of the steel structure with that of the pre-caste concrete foundation. Towers can have different heights. Maximum height is 36 m. These towers are designed for wind load of 160 km/h. These towers are recommended for urban areas and they also can be very useful in rural areas, where you have higher sites and you need bigger load. These towers we have in two types.First type is lighter tower that has the same loading capacity as guyed tower and they are designed for light loads (three GSM/UMTS antennas and one 1,2 or two 0,6 MW dishes). These towers are mobile or rapid deployment towers and they can be used anywhere in the country. Second type are heavy duty towers (6 GSM/UMTS antennas and two 0,6 MW dishes). These towers are suitable for medium and heavy loads (6 GSM/UMTS antennas + 2 MW - 0,6m) - which are usually used in all metropolitan and urban areas and surrounding residential and industrial suburbs. Both types need site 10m x 10m large and their main benefit is the time that is required for their installation. These towers can be finished from ground zero up to complete tower prepared for equipment installation in two to three days. And last but not least, for these towers you do not need any civil works. These towers are designed without classic foundations and whole tower construction is based on the ground surface. We have prepared two versions of tower base – one, with (pre-prepared) concrete counter weights and another version with aggregate counter weights. These towers are designed for soil bearing capacity that is 150 KN/m2 or higher.

Maranyundo hill site,65m lattice tower

Lattice towers need civil works for reinforced concrete foundation. Tower is directly mounted into the concrete foundation with anchor bolts. Towers can have different heights. Maximum height is 100 m. These towers are recommended for all situations where Telecommunication Companies needs heavy load and they are mainly used for quality upgrade of existing network. These towers are designed for medium/heavy loads (6 GSM/UMTS antennas and 3-5 MW (0,6-1,8m) - these loads are required in all rural areas along national and secondary roads and in small towns. These are typically areas where Transmission M/W hop distances will exceed 30 km. These sites are typically built on farms or on hills and mountains. Heavy loads (6 GSM/UMTS antennas and 4-10 MW (0,6 – 2,4m) - these loads are required when a site is determined to be a Transmission node or hub. The typical height of these towers is higher than 50m. These sites are typically built along rural roads or on hills and mountains) and for ultra heavy loads (9 GSM/UMTS antennas and 10 – 30 MW (0,6 – 2,0m) - these loads are required when a tower is required at a Mobile Switching Centre. The typical height of these towers is 55 to 100 meters in height. These sites are typically built in big cities and towns and they are situated close to the switching centre. All tower are designed to take a wind load up to 160km/h.

LATTICE TOWERS

LEGEND A/B/C A: Design Wind Speed (km/hr) B: Total antenna area on the tower (m2) C: Deflection of the top portion of the tower under the given wind speed and antenna load (degree)

ADB site.30m lattice tower

Gikomero site,36m lattice tower

26-35-45-50-60-70m guyed towers (these towers we are recommending for rural areas where companies need to set up coverage in very short period and these towers are most suitable for network widening) – these towers are designed for light loads (three GSM/UMTS antennas and one 1,2 or two 0,6 MW dishes) - these loads are required in urban areas and surrounding residential suburbs and these sites are under regime of special requirements demanded from councils, landlords or environmentalists) and in situations where telecommunication company needs fast deployment of towers. These towers are mostly mobile or rapid deployment towers and they can be used anywhere in the country. Site area that is needed for these types of towers depends from the tower height (the distance between the tower base and peripheral anchors must be = Tower h x 0,57). The main benefit from these towers is that their installation is very fast. For example foundation works are finished in one day and after seven days of concrete healing you can start installation of tower that is taking from two to four days – that depends from height of tower (for towers from 26m to 50m installation of tower takes two days and for towers that are from 50 up to 70m height installation is taking from three to four days). These towers are designed for 40m/s wind load and their foundations are designed for soil with bearing capacity 150KN/m2 or higher.

GUYED TOWERS

6-18m rooftop towers – poles and masts (these towers we are recommending for urban areas where companies need to set up coverage in very short period and these towers are most suitable for coverage of cities) – these towers are designed for light loads (three GSM/UMTS antennas and one 1,2 or two 0,6 MW dishes - these loads are required in urban areas and surrounding residential suburbs and these sites are under regime of special requirements demanded from councils, landlords or environmentalists) and in situations where telecommunication company needs fast deployment of network. These towers are mostly mobile or rapid deployment towers and they can be used anywhere in the country. The main benefit from these towers is that their installation is very fast. These towers are designed for 40m/s wind load.

ROOFTOP TOWERS

Branex Ltd also offers various power solutions for telecommunication sites. Our generators are powered with engines made by well known companies such as Vovlo, Iveco, Perkins etc. They cover power range from 15kVA up to 1125kVA and they can be customized for indoor and outdoor use. For outdoor purposes we are producing generators in shelter that provides reduction of noise (that generator is producing in power mode) in accordance with European directive 2000/14/CEE and protection from all weather conditions.

Our generators have following features:

- Standby power from 15kVA to 1125kVA, Prime power from 13kVA to 1122kVA- VOLVO, IVECO, PERKINS engines with water cooler- Electronic and mechanic engine control- Automatic voltage regulation, +/-1%- 300% of working range in 10 sec- Protection fuse (thermo and power protection)- Electronic battery charger- Automatic cooler fluid heater- Led batteries- Generator microprocessors control panel- Manuel start- Automatic start- Network synchronization- ATS- Shelter with noise reduction – for outdoor units- Transport and forklift hooks- Integral fuel tank (for minimum of 12 hours of work within working range of 100%)- Emergency OFF switch- Software for remote control

GENERATORS

StructureThe fence for integrated site is bonded with anti-theft bolts and nuts. The fence is using high-density materials, it is capable of endure high-level of impact.Surface of the fence is treated with hot dipped galvanization. It has high-level of corrosion, rust and salt-fog resistance. The protection material for surface treatment can be customized by customer’s order. The appearance and size of the fence is under the industrial standard or can be modified on customer’s order.Razor Wire is installed on top of every part of the fence; it is effective for anti-theft. In addition other anti-theft equipment can be installed by order.Standard manufacturing, the fence parts are manufactured in the factory, only transportation and installation needed to set it up. It ensure the quality of the fence, also shortens installation lead-time.

FENCES

Karisimbi site,24m guyed tower

Bibare site,24m lattice tower

InstallationFence is easy for installation. It greatly shortens the installation lead-time, reduces the activity on site.Able to look through the fence, avoid blind spot on the site, and reduce the burglarproof then the maintenance cost.Able to conquer the install limitation on site, then ensure the quality of installation and lengthen it tenure of usage.TransportationOur fence is manufactured by highest industrial standard, suitable for road, rail, and maritime transportation.ApplicationFor sites and stations or other location of telecom base, equipment base etc.SpecsFence consists of: mid standing pillar, Rim angle pillar, crosspiece, rail, razor wire support and razor wire per request of client. All steel surfaces are treated with hot dipped galvanization; galvanization thickness by industrial standardization GB/T 13912. Galvanization surface is flat, not impurity.To ensure the quality of the fence, all rail and pillar are formed with rolling mill. The thickness of steel material is 2.5mm minimal. Fence is equipped with burglarproof bolts and nuts. The height of the fence is 2350mm, piercing top. Rails and pillars are at the same height. All joint points are connected with burglarproof bolts, nuts and matching spring washers.Razor Wire (produced and supplied per client request)700mm Razor Wire is installed on the top of the fence. Wire gauge is fixed on razor wire support by hot dipped galvanized wire. The support is 500mm higher than the pillars for easy installation. Razor Wire is with steel flat blade, installed along with the fence.

Bibare site,24m lattice tower

Wherever you need an equipment shelter, our highly experienced engineering and production teams are ready to provide a cost-efficient design. We get the job done by offering unlimited custom-built shelter solutions, of any size and shape that you might need. Our shelters are mobile, modular and express, there is no such thing as a "standard" shelter plan — we will not ask you to accept unwanted items or compromise anything you need. Every shelter we build is designed, engineered and delivered to meet your site requirements and aesthetics - including a reliable integrated electrical system, cable entry, ladders, HVAC and lighting; in addition to specified alarms and backup components.

Components specification:

Shelter Wall(0.6mm+80mm+0.6mmpolystyrene) – sandwich technologyShelter Roof panel(0.6+80mm+0.6 polystyrene) – sandwich technologyShelter Floor(0.6mm+20mmplywood+80mmpolyurethane+0.6mm ) – sandwich technology Shelter Door(2m*0.9m) with lock Antistatic floorRF entry windowShelter Steel Base Frame(galvanization)Standard fixtures - cable inlets, cable tray (300mm and 150mm), lighting system (Indoor fluorescent lamp and switch (40w, Outdoor Waterproof night light, backup socket, cable trunking (PVC/40mm; PVC/80mm), emergent light, protection cage for air-condition units, door access, etc.DC ventilation system Different accessories - Angle aluminum, Power Sockets, Fire extinguisher, sealant, fastener, operation instruction, packing list, approved certificate for products, installation facility, 3 packing boxes etcOptional fixtures - AC Power Distribution Panel (DB), Power Line Surge Protection, Air Conditioner (20000and 18000 each, 2 sets), Alarm System (including environment control and temperature control), Etc.

Main Advantages:Flexible to move, Convenient to transport, Rapid to construct, Fit for various weather conditions, Applicable for traffic lines, scenic spots, commercial centers and remote regions, A good choice for BTS/GSM/CDMA networks, consist of shelter body, steel structure base/others, electric and light, environment monitor, temperature control , electrical power supply, etc.

SHELTERS

Cyasemakamba site,24m lattice tower

• Mobiltel EAD, Bulgary

• Siemens

• Ericsson

• VIP, Macedonia

• VIP, Serbia

• SI-Mobile, Slovenia

• Eronet, Bosnia and Herzegovina

• 17 - 57 m lattice telecom towers, Nec, Ethiopia

• Glabacom project 20 - 30 - 70 m lattice telecom towers, Alcatel Lucent, Nigeria

• 30 - 40 - 50 - 70 m. lattice telecom towers, Alcatel Lucent, Philippines

• 40 - 60 lattice telecom towers, Gulf Turrets, U.A.E.

• 15, 25, 35, 45, 55, 60 m lattice telecom towers, Nera Networks, Libya

• 30 - 40 m lattice telecom towers, Telecom Development, Afghanistan

• Libertis project 15 - 80 m lattice telecom towers, Alcatel, Gabon

• Palmet Pakistan project, Nokia, Pakistan

These types of towers have been installed on the following projects:

• Magticom telecom project, Powertech, Georgia

• Al Atheer project rooftop & lattice telecom towers, Powertech, Iraq

• Lattice telecom towers, Watan Serve, Algeria

• Lattice telecom towers, C-team, Germany

• MTN Areeba project 20 - 30 - 60 m lattice telecom towers, Bridges, Sudan

• Asiacell project 40 - 80 m lattice telecom towers, Asiacell, Iraq

• Syria ste pmp project 5 - 50 m lattice telecom towers, Intracom, Syria

• Vodafone project 10 - 60 m lattice telecom towers, Motorola, Turkey

• Turkcell project 20 - 80 m lattice telecom towers, Turkcell, Turkey

• Maroc connect lattice telecom towers, Alcatel Lucent, Morocco

• Maroc connect lattice telecom towers, SBI & T partners, Morocco

• 76 Guyed Towers Project, Uganda Telecom, Uganda

• 50 SST Lattice telecom towers, Uganda Telecom, Uganda

• 136 telecommunication sites project, Rwandatel, Rwanda

• 18 backbone towers, GreenN CI, Cote D' Ivore

Kamonyi site45m lattice tower

Branex Co Ltd.Mosta MST 06, Malta27 Grognet Streetoffice@branexltd.com