Cobwebs and ladybugs

Pulling the gas tank and other parts

Rusty from sitting on damp ground

Gas tank going to the rad shop for cleaning

A peek underneath – the three holes are air intakes back through the box frame to the air filter box

Freshly painted wheel rims – ready to install tires

A box of parts which were removed when the engine was pulled for the prior owner – dirty but in great shape

Motor in the back

Carb still attached by the choke and throttle cables

Air filter box – the sticker is in Italian (should have been in English) Must have run out the day it was built

Advising to use an AC Airac Flat Pack air filter and it gives the part number for reference

The English version is on the left

Mice had made a nest inside the air filter box

I’ve marked with red arrows where the center bed attachments are located

This shows removal of the long bolts through the box frame attaching the bed to the frame

They’re quite long

Rear side frame bolts attaching the bed, located just behind the rear fender

These short bolts are at the very rear of the box frame members, attaching the bed

This is an in-line 8amp fuse holder for the interior light in the Van box

Once dismantled the wire can be pulled through the back of the cab and the light and wiring removed

I’ve removed the carburator to prepare it for cleaning

Van box interior light and wiring harness packaged

Left upper tailgate latch

Right upper tailgate latch

Underside of upper tailgate locking handle. I can tell that a Canadian worked on this – Robertson screw!

8mm socket used to remove hidden screw holding the handle in place

Upper tailgate pieces and tools required for removal

Tailgate prop – lower attachment (home made)

Upper attachment for the prop

Split pin removal – upper right hinge

Upper left hinge – punching out the split pin with a tapered punch

Upper tailgate removed

Only the latches to be removed from the upper tailgate

Driving out the split pin for the lower tailgate - use lots of WD40 and tap it back and forth to free, then remove

Driving out the left split pin for the tailgate

Flat punch to free the split pin by driving it back and forth. Punch identical size to split pin to drive it in partway. Tapered punch to drive split pin along its edges until free.

Tailgate removed

Remove the weatherstripping

Remove tail lights. Usually rusted so lots of Liquid Wrench and go gently on the nuts to free them – patience!