Upload
others
View
0
Download
0
Embed Size (px)
Citation preview
Classic 500Seat Modification
FIRST ATTEMPT
ORIGINAL SEAT
base plate after removing the rexine cover and the foam
adding hard rubber-foam towards the back.Another large layer of this material was added, missed the picture.
putting the original seat foam over the base plate. scooping the material from centre.
adding additional material towards the back, for lower back support.
shaping /finishing the material
covering the entire seat with a thin layer of foam (thickness:1/4 of an inch)
putting a fresh tailor-made rexine cover.
ORIGINAL SEAT AFTER MODIFICATION
Installed on the bike
Installed on the bike
RESULT:
The Experiment was NOT successful.The raised lower back support felt good,but the angle was too steep and pushed
my butt towards the tank.
Overall, not very happy with this modification.
NEXT STEPS:Further modification, to be shared in next PDF.
:)