Embed Size (px)
Citation preview
LEDdynamics, Inc.802.728.4533 P802.728.3800 [email protected] TEGulatorTM
TEGpro802.728.4533 P802.728.3800 [email protected] Page 1 of 2
©2016 TEGpro www.tegpro.com.Speci�cations subject to change without notice. Sep, 2016
TEGproTM
Recycling waste heat for a cooler tomorrow
TEGproTM
Recycling waste heat for a cooler tomorrow
Product Overview
Geometric Characteristics
TE-MOD-1W2V-40S1 Watt Thermoelectric Module
Hot Side Temperature
Cold Side TemperatureOpen Circuit Voltage (V)
Matched Load Resistance (ohms)
Matched load output voltage (V)Matched load output current (A)Matched load output power (W)
100 °C
20 ° C4.0
3.252.60.8
0.84
26≈ 7
40mm
Negative lead wire
Positive lead wire
Hot side attached to heat source
Cold Side Attached to Heat Sink for Heat Dissipation
The Tegpro 1 Watt Low Temperature Thermoelec-tric Module is ideal for body heat recovery & hydronic waste heat recovery applications
Our TEG power module is specifcally designed and manufacturedto convert high temperature heat sources directly into electricity.The Bi-Te based TEG power modules can operate at temperaturesas high as 230 °C continuously. The module will generate DC voltage if there is a temperature di�erence across the module. Power is generated as the temperature di�erence across the module increases. The e�ciency of the module will also increase as well. Thermally conductive graphite sheets have been appliedto both sides of the ceramic plates to provide low contact thermal resistance. Therefore you do not need to apply thermal grease or other heat transfer compounds when you install the module. The graphite sheet works very well in high temperatures.
Heat �ow across the module (W)Heat �ow density(W cm-2)
40m
m
LEDdynamics, Inc.802.728.4533 P802.728.3800 [email protected] TEGulatorTM
TEGpro802.728.4533 P802.728.3800 [email protected]
©2016 TEGpro www.tegpro.com.Speci�cations subject to change without notice. Nov, 2016 - Rev 1.0
TM
TEGproTM
Recycling waste heat for a cooler tomorrow
TE-MOD-1W2V-40SThermoelectric Module
.
Matched load current and matched load voltage vs DT
Output power vs DT
0 20 40 60 80 1000.0
0.5
1.0
1.5
2.0
2.5
0.0
0.2
0.4
0.6
0.8
1.0
Mat
ched
Loa
d C
urre
nt /
A
DT / C
V / egatloV daoL dehcta
M
0 20 40 60 80 1000.0
0.3
0.6
0.9
1.2
1.5
Out
put P
ower
/ W
DT / C
Note:Module is rated for 100° C
Performance Curves of TE-MOD-1W2V-40S
Page 2 of 2
