Upload
alban-mcdonald
View
217
Download
4
Tags:
Embed Size (px)
Citation preview
• CHAPTER 8• Quality of Service
Quality of Service
Integrated services (IntServ)• Ensure that a specific flow of traffic is going to receive the appropriate level of bandwidth across the entire network.• Resource ReSerVation Protocol (RSVP)
Differentiated Services (DiffServ)•Used in Large Networks•Classifies Traffic•Type of Service (ToS)•DiffServ Code Point (DSCP)
Delay Budget
Edge Functions
•Classify traffic as close to the edge as possible!
•Provider Edge
•Customer Edge
Header Compression:
cRTP will compress traffic by recording header information and incrementally increasing it per each received packet
cRTP Configuration:
Leased line!Interface serial 0/0/0 ip address 192.168.121.18 255.255.255.252 no ip mroute-cache ip rtp header-compression encapsulation ppp
cRTP Configuration:
Frame Relay!Interface serial 0/0/0 ip address 192.168.120.10 255.255.255.0 encapsulation frame-relay no ip route-cache no ip mroute-cache frame-relay ip rtp header-compression
Queuing:
•Identify Traffic•First in First out (FIFO) (Single Que)•Weighted Fair Queuing•Custom Queuing•Priority Queuing•Class Based Weighted Fair Queuing•Low Latency Queuing
Weighted Fair Queuing (WFQ):
• Identifies Traffic Flows Uses Source and Destination Addresses Protocol Type Port Number Qos/Tos Values
• Shares Traffic in a Fair Manner Low-bandwidth get Priority High-bandwidth shares remaining
bandwidth
•Enabled on an interface by the fair-queue command
Weighted Fair Queuing (WFQ):
• Affected by IP Precedence (0-7) Frame-Relay FECN Frame-Relay BECN Frame-Relay DE bits
• Options to the fair-queue Command congestive-discard-threshold (64) (16-4096) dynamic-queues (256) (16,32,64,128,256,…4096) reservable-queues (0) (0-1000)
• Not meant for use on links with bandwidth greater than 2.048 Mbps
Custom Queuing (CQ):
• Specifies a percentage of available Bandwidth
Max 16 output queues Serviced Sequentially Dynamic allocation of unused bandwidth
interface serial 0/0/0 ip address 20.0.0.1 255.0.0.0 custom-queue-list 1!queue-list 1 protocol ip 1 list 101queue-list 1 default 2queue-list 1 queue 1 byte-count 4000queue-list 1 queue 2 byte-count 2000!access-list 101 permit udp any any range 16380 16480 precedence 5access-list 101 permit tcp any any eq 1720
Priority Queuing:
• Four traffic queues (High, Normal, Medium, Low)• Each queue is serviced till empty• Can starve traffic flows
interface serial 0/0/1 ip address 192.168.121.17 255.255.255.248 encapsulation ppp no ip mroute-cache priority-group 1!access-list 101 permit udp any any range 16384 16484access-list 101 permit tcp any any eq 1720priority-list 1 protocol ip high list 101
Priority Queuing:
CB-WFQ (Class Based Weighted Fair Queuing):
• Can run on links up to T3• Defines what constitutes a class• Specify the exact amount of bandwidth allocated• Specify the minimum amount of bandwidth allocated• 64 different classes• Each class is associated with a separate queue• Can be skewed to simulate PQ
PQ within CB-WFQ (Low Latency Queuing):
• Gives absolute priority to voice traffic
Traffic Classification:
• Three bits in the ToS field of the IP Header• in-band QoS
DSCP, TOS, and COS:
Traffic Classification:
• Three bits in the ToS field of the IP Header• in-band QoS
Traffic Classification:
• Can be set by destination phone number
dial-peer voice 650 voip destination-pattern 650 ip precedence 5 session target RAS
Policy Routing:
• Can reset IP Precedence bits
• Can base policies on IP addresses, Port numbers, Protocols, or Packet size• Uses route-maps to filter• Can use any ACL
interface FastEthernet0/0 ip address 192.168.15.18 255.255.255.0 ip policy route-map RESET-PRECEDENCE!access-list 105 permit ip any anyroute-map RESET-PRECEDENCE permit 10 match ip address 105 set ip precedence routine
RSVP:
• Each interface must be explicitly configured for RSVP• The receiving station is the requester of the service
• interface-kbps: reserved bandwidth per interface (1-10,000,000)• single-flow-kbps: amount of bandwidth allocated to a flow (1-10,000,000)• default: 75% of available bandwidth if not specified• show ip rsvp reservation• Scalability issues
ip rsvp bandwidth [interface-kbps] [single-flow-kbps]
Traffic Policing:
• Define the bandwidth limit for an application• Rate limiting tools• Used at the edge• Traffic dropped based upon the bandwidth limit• Subscriber cannot exceed the bandwidth set by contractrate-limit {input | output} bps burst-normal burst-max conform-action action exceed-action action
Traffic Shaping:
• Control usage of available bandwidth• Establish traffic policies• Regulate traffic flow to avoid congestion
traffic-shape rate bit-rate [burst-size [excess-burst-size]]
Traffic Shaping:
Interface serial0/0/0 encapsulation frame-relay traffic-shape rate 32000 4000 0
Interface serial0/0/0 traffic-shape group 101 64000 8000 0!access-list 101 permit tcp any eq ftp any
Fragmentation:
Packet size in bytes/sec x 8 = Packet size in bits/secPacket size in bits/sec / Circuit size in bits/sec = Time required to transmit
1500 bytes/sec x 8 = 12000 bits/sec12000 bits/sec / 56000 bits/sec = 0.214 sec = 214 msec
Fragmentation MTU:
interface serial 0/0/0 ip mtu 300 no ip address encapsulation frame-relay fair-queue 64 256 1000!interface serial0/0/0.1 point-to-point ip mtu 300 ip address 40.0.0.7 255.0.0.0
interface serial 0/0/0 mtu 300 no ip address encapsulation frame-relay fair-queue 64 256 1000!interface serial0/0/0.1 point-to-point mtu 300 ip address 40.0.0.7 255.0.0.0
Congestion Avoidance:
•WRED Randomly drops packets when queue
gets to a set % of capacity Uses TCP window size to reduce flow
Cisco Auto QoS:
•On the interface to the phone
Switch(config)#interface fa0/1Switch(config-if)#auto qos voip ? cisco-phone Trust the QoS marking of the Cisco IP Phone cisco-softphone Trust the QoS marking of the Cisco IP Softphone trust Trust the DSCP/CoS markingSwitch(config-if)#auto qos voip cisco-phone
Cisco Auto QoS:
•On the interface to the Router
Switch(config)#interface fa0/1Switch(config-if)#auto qos voip ? cisco-phone Trust the QoS marking of the Cisco IP Phone cisco-softphone Trust the QoS marking of the Cisco IP Softphone trust Trust the DSCP/CoS markingSwitch(config-if)#auto qos voip trust
CME(config)#interface fa0/1CME(config-if)#auto ? discovery Configure auto Discovery qos Configure AutoQoSCME(config-if)#auto qos voip trust
End of Chapter 8