Upload
tesfaye-kebede
View
224
Download
0
Embed Size (px)
Citation preview
8/11/2019 Chapter 1 Hydrolic Machine
http://slidepdf.com/reader/full/chapter-1-hydrolic-machine 1/34
8/11/2019 Chapter 1 Hydrolic Machine
http://slidepdf.com/reader/full/chapter-1-hydrolic-machine 2/34
Introductionunif orm flow: flow velocity is the same magnitude and direction at every point in the
fluid.
non-uniform: If at a given instant, the velocity is not the same at every point theflow. (In practice, by this definition, every fluid that flows near a
solid boundary will be non-uniform - as the fluid at the boundarymust take the speed of the boundary, usually zero. However if thesize and shape of the of the cross-section of the stream of fluid isconstant the flow is considered uniform.)
steady: A steady flow is one in which the conditions (velocity, pressure andcross-section) may differ from point to point but DO NOT change
with time.
unsteady: If at any point in the fluid, the conditions change with time, the flowis described as unsteady. (In practice there is always slight variationsin velocity and pressure, but if the average values are constant, theflow is considered steady.)
8/11/2019 Chapter 1 Hydrolic Machine
http://slidepdf.com/reader/full/chapter-1-hydrolic-machine 3/34
8/11/2019 Chapter 1 Hydrolic Machine
http://slidepdf.com/reader/full/chapter-1-hydrolic-machine 4/34
Turbulent Flow
the particles move in an irregular manner through the flow field.
Each particle has superimposed on its mean velocity fluctuating velocitycomponents both transverse to and in the direction of the net flow.
Fig 2 Turbulent Flow
Transition Flow
exists between laminar and turbulent flow. In this region, the flow is very unpredictable and often changeable back
and forth between laminar and turbulent states.
Modern experimentation has demonstrated that this type of flow may
comprise short ‘burst’ of turbulence embedded in a laminar flow.
Particlepaths
8/11/2019 Chapter 1 Hydrolic Machine
http://slidepdf.com/reader/full/chapter-1-hydrolic-machine 5/34
Mass flow rate
mass flow rate =
time =
Volume flow rate – Discharge
Discharge/volume flow rate =
=
mass of fluidtime taken to collect the fluid
mass
mass flow rate
volume of fluid
time
mass fluid rate
density
m
r =
8/11/2019 Chapter 1 Hydrolic Machine
http://slidepdf.com/reader/full/chapter-1-hydrolic-machine 6/34
Basic principle of flow1. The law of conservation of matter
stipulates that matter can be neither created nor destroyed, though it may betransformed (e.g. by a chemical process).
Since this study of the mechanics of fluids excludes chemical activity from
consideration, the law reduces to the principle of conservation of mass.
2. The law of conservation of energy
states that energy may be neither created nor destroyed.
Energy can be transformed from one guise to another (e.g. potential energycan be transformed into kinetic energy), but none is actually lost.
Engineers sometimes loosely refer to ‘energy losses’ due to friction, but infact the friction transforms some energy into heat, so none is really ‘lost’.
8/11/2019 Chapter 1 Hydrolic Machine
http://slidepdf.com/reader/full/chapter-1-hydrolic-machine 7/34
3. The law of conservation of momentum
states that a body in motion cannot gain or losemomentum unless some external force is applied.
The classical statement of this law is Newton'sSecond Law of Motion, i.e
force = rate of change of momentum
8/11/2019 Chapter 1 Hydrolic Machine
http://slidepdf.com/reader/full/chapter-1-hydrolic-machine 8/34
Continuity (Principle of Conservation of Mass )
• Matter cannot be created nor destroyed - (it is simply changed in to adifferent form of matter).
• This principle is known as the conservation of mass and we use it in
the analysis of flowing fluids. • The principle is applied to fixed volumes, known as control volumes
or surfaces
CONTROL
VOLUME
Control surface
OutflowInflow
Figure 3.10: A control volume
8/11/2019 Chapter 1 Hydrolic Machine
http://slidepdf.com/reader/full/chapter-1-hydrolic-machine 9/34
For any control volume the principle of conservation of mass says
Mass entering = Mass leaving + Increase of mass in the control. per unit time per unit time volume per unit time
For steady flow:(there is no increase in the mass within the control volume)
Mass entering per unit time = Mass leaving per unit time
Figure 3.11: A streamtube section
Mass entering per unit time atend 1 = Mass leaving per unittime at end 2
8/11/2019 Chapter 1 Hydrolic Machine
http://slidepdf.com/reader/full/chapter-1-hydrolic-machine 10/34
flow is incompressible, the density of the fluid is constant throughout the fluidcontinum. Mass flow, m, entering may be calculated by taking the product
(density of fluid, r ) (volume of fluid entering per second Q)
Mass flow is therefore represented by the product r Q, hence
r Q (entering) = r Q (leaving)
But since flow is incompressible, the density is constant, so
Q (entering) = Q (leaving)
This is the ‘continuity equation ’ for steady incompressible flow.
If the velocity of flow across the entry to the control volume is measured, and thatthe velocity is constant at V 1 m/s. Then, if the cross-sectional area of the streamtubeat entry is A1,
Q (entering) = V 1 A1
Thus, if the velocity of flow leaving the volume is V 2 and the area of the streamtubeat exit is A2, then
Q (leaving) = V 2 A2
Therefore, the continuity equation may also be written as
V 1 A1 = V 2 A2
8/11/2019 Chapter 1 Hydrolic Machine
http://slidepdf.com/reader/full/chapter-1-hydrolic-machine 11/34
Application of Continuity Equation
We can apply the principle of continuity to pipes with cross sections whichchange along their length.
A liquid is flowing from left to right and the pipe is narrowing in the samedirection. By the continuity principle, the mass flow rate must be thesame at each section - the mass going into the pipe is equal to the massgoing out of the pipe. So we can write:
r 1 A1V 1= r 2 A2V 2
As we are considering a liquid, usually water,which is not very compressible, the densitychanges very little so we can say r 1 = r 2 = r .This also says that the volume flow rate is
constant or that Discharge at section 1 = Discharge at section
2
Q1 = Q2
A1V 1 = A2V 2 or V 2 =
Fig Pipe with contraction
A1V 1
A2
8/11/2019 Chapter 1 Hydrolic Machine
http://slidepdf.com/reader/full/chapter-1-hydrolic-machine 12/34
The continuity principle can also be used to determine thevelocities in pipes coming from a junction.
Fig: A pipe with junction
Total mass flow into the junction = Total mass flow out of thejunction
r 1Q1 = r 2Q2 + r 3Q3
When the flow is incompressible (e.g. water) r 1 = r 2 = r
Q1 = Q2 + Q3
A1V 1 = A2V 2 + A3V 3
8/11/2019 Chapter 1 Hydrolic Machine
http://slidepdf.com/reader/full/chapter-1-hydrolic-machine 13/34
8/11/2019 Chapter 1 Hydrolic Machine
http://slidepdf.com/reader/full/chapter-1-hydrolic-machine 14/34
Work and Energy
(Principle Of Conservation Of Energy)
friction: negligible
sum of kinetic energy and gravitational potential energy is
constant. Recall :
Kinetic energy = ½ mV 2
Gravitational potential energy = mgh
(m: mass, V : velocity, h: height above the datum).
8/11/2019 Chapter 1 Hydrolic Machine
http://slidepdf.com/reader/full/chapter-1-hydrolic-machine 15/34
To apply this to a falling body we have an initial velocity of zero, andit falls through a height of h.
Initial kinetic energy = 0
Initial potential energy = mgh
Final kinetic energy = ½ mV 2
Final potential energy = 0We know that,
kinetic energy + potential energy = constant
mgh = ½ mV 2 or ghV 2
8/11/2019 Chapter 1 Hydrolic Machine
http://slidepdf.com/reader/full/chapter-1-hydrolic-machine 16/34
continuous jet of liquid
a continuous jet of water coming from a pipe with velocity V 1. One particle of the liquid with mass m travels with the jet and falls from
height z 1 to z 2. The velocity also changes from V 1 to V 2. The jet is traveling in air where the
pressure is everywhere atmospheric so there is no force due to pressure
acting on the fluid. The only force which is acting is that due to gravity. The sum of the kinetic
and potential energies remains constant (as we neglect energy losses due tofriction) so :
mgz 1 + mV 12 = mgz 2 + mV 2
2
As m is constant this becomes :
V 12 + gz 1 = V 22 + gz 2
Figure: Thetrajectory of ajet of water
8/11/2019 Chapter 1 Hydrolic Machine
http://slidepdf.com/reader/full/chapter-1-hydrolic-machine 17/34
Flow from a reservoir
8/11/2019 Chapter 1 Hydrolic Machine
http://slidepdf.com/reader/full/chapter-1-hydrolic-machine 18/34
It is based on the law of conservation of momentum or on the momentum
principle, which states that the net force acting on a fluid mass is equal to the
change in momentum of flow per unit time in that direction. The force acting on
a fluid mass‘m’
is given by theNewton’s
second law of motion,
8/11/2019 Chapter 1 Hydrolic Machine
http://slidepdf.com/reader/full/chapter-1-hydrolic-machine 19/34
8/11/2019 Chapter 1 Hydrolic Machine
http://slidepdf.com/reader/full/chapter-1-hydrolic-machine 20/34
8/11/2019 Chapter 1 Hydrolic Machine
http://slidepdf.com/reader/full/chapter-1-hydrolic-machine 21/34
8/11/2019 Chapter 1 Hydrolic Machine
http://slidepdf.com/reader/full/chapter-1-hydrolic-machine 22/34
8/11/2019 Chapter 1 Hydrolic Machine
http://slidepdf.com/reader/full/chapter-1-hydrolic-machine 23/34
8/11/2019 Chapter 1 Hydrolic Machine
http://slidepdf.com/reader/full/chapter-1-hydrolic-machine 24/34
8/11/2019 Chapter 1 Hydrolic Machine
http://slidepdf.com/reader/full/chapter-1-hydrolic-machine 25/34
8/11/2019 Chapter 1 Hydrolic Machine
http://slidepdf.com/reader/full/chapter-1-hydrolic-machine 26/34
8/11/2019 Chapter 1 Hydrolic Machine
http://slidepdf.com/reader/full/chapter-1-hydrolic-machine 27/34
8/11/2019 Chapter 1 Hydrolic Machine
http://slidepdf.com/reader/full/chapter-1-hydrolic-machine 28/34
8/11/2019 Chapter 1 Hydrolic Machine
http://slidepdf.com/reader/full/chapter-1-hydrolic-machine 29/34
8/11/2019 Chapter 1 Hydrolic Machine
http://slidepdf.com/reader/full/chapter-1-hydrolic-machine 30/34
8/11/2019 Chapter 1 Hydrolic Machine
http://slidepdf.com/reader/full/chapter-1-hydrolic-machine 31/34
8/11/2019 Chapter 1 Hydrolic Machine
http://slidepdf.com/reader/full/chapter-1-hydrolic-machine 32/34
8/11/2019 Chapter 1 Hydrolic Machine
http://slidepdf.com/reader/full/chapter-1-hydrolic-machine 33/34
8/11/2019 Chapter 1 Hydrolic Machine
http://slidepdf.com/reader/full/chapter-1-hydrolic-machine 34/34