CellCore Tool Installation Procedure

1 | P a g e

Revision A – 2018.8.16

Controller Setup: The controller setup for the CellCore tool is exactly the same as that of the LiveWire tool.

Press [Tool Setup] button

Press the [Install] button

CellCore Tool Installation Procedure

2 | P a g e

Revision A – 2018.8.16

Press the Type drop down menu and select LiveWire w/WLAN

Enter the IP address and Press [OK] button

The screen will display Status: Connection timed out until the tool is setup

CellCore Tool Installation Procedure

3 | P a g e

Revision A – 2018.8.16

CellCore tool Setup:

Connect cable to PC (USB cable - type A male to micro B male)

Connect cable to CellCore tool

Start LiveWire RF Configuration program

CellCore Tool Installation Procedure

4 | P a g e

Revision A – 2018.8.16

Check the IRDA Serial radio button and select correct communication port Enter:

SSID (router) IP address (CellCore tool IP address) Subnet mask (router) Default Gateway (router)

Press [Yes] button

Press [OK] button To save the changes, reset the CellCore tool by removing the battery and waiting 3 minutes for the tool to completely power down

CellCore Tool Installation Procedure

5 | P a g e

Revision A – 2018.8.16

The controller screen will display Status: Needs User Acceptance

Verify the correct CellCore tool is displayed and Press the [Accept] button

Press the [Accept] button

CellCore Tool Installation Procedure

6 | P a g e

Revision A – 2018.8.16

The controller screen will display Status: Online

The CellCore tool and controller are now paired and can be programmed.