Upload
kurt-ragsdale
View
228
Download
0
Embed Size (px)
Citation preview
8/8/2019 CCNA2 Final Pract Test
http://slidepdf.com/reader/full/ccna2-final-pract-test 1/4
Top of Form
What are three features of CDP? (Choose three.)
tests Layer 2 connectivity
provides a layer of security
operates a OSI layers 2 and 3
enabled by default on each interface
used for debugging Layer 4 connectivity issues
provides information on directly connected devices that have CDP enabled
Bottom of Form
What are two functions of a router? (Choose two.)
It connects multiple IP networks.
It controls the flow of data via the use of Layer 2 addresses.
It determines the best path to send packets.
It manages the VLAN database.
It increases the size of the broadcast domain.
Which router component is used to store the routing table?
Flash
NVRAM
ROM
SDRAM
Top of Form
Refer to the exhibit. Which two routes are child routes? (Choose two.)
8/8/2019 CCNA2 Final Pract Test
http://slidepdf.com/reader/full/ccna2-final-pract-test 2/4
10.0.0.0
10.1.2.0
10.2.2.0
192.168.1.0
192.168.2.0
Bottom of FormTop of Form
Refer to the exhibit. Routers R1 and R3 use different routing protocols with default administrative distancevalues. All devices are properly configured and the destination network is advertised by both protocols.
Which path will be used to transmit the data packets between PC1 and PC2?
The packets will travel via R2-R1.
The packets will travel via R2-R3.
The traffic will be load-balanced between two paths — via R2-R1 and via R2-R3.
The packets will travel via R2-R3, and the other path via R2-R1 will be retained as the backup path
Bottom of FormTop of Form
8/8/2019 CCNA2 Final Pract Test
http://slidepdf.com/reader/full/ccna2-final-pract-test 3/4
Refer to the exhibit. All routes are advertised and fully operational on all routers. Which statement is true aboutthe path that the data will take from router A to router B?
If EIGRP is used with default configurations, the data will be equally distributed between two paths — A, D,
B and A, C, B.
If RIPv1 is used with default configurations, the data will be load-balanced on all paths.
If EIGRP and OSPF are both used with default configurations, the data will be sent through paths learnedby the OSPF protocol.
If RIPv2 is used with default configurations, the data will be equally distributed between two paths — A, D,B and A, C, D.
Bottom of FormTop of Form
Refer to the exhibit. The network administrator issues the command no ip classless on Router1. What forwardingaction will take place on a packet that is received by Router1 and is destined for host 192.168.0.26?
The packet will be dropped.
The packet will be forwarded to the gateway of last resort.
The packet will match the 192.168.0.0 network and be forwarded out Serial 0/0.
The packet will most closely match the 192.168.0.8 subnet and be forwarded out Serial 0/1.