Like the first step of the step by step guide, here I am checking that there are 10 CCT fresnels. I also checked from visuals that there barn doors and gel frames in the light and that they are the right way round, if there wasn’t or they were the wrong way round, I would get the ladders and insert a gel frame or barn doors.

Here is the dimmer pack. I am first checking that the dimmer pack is switched and then I checked whether there were 10 plugs plugged into the dimmer. This would confirm that all of the 10 CCT fresnels are plugged in. If there are not 10 plugs plugged in, I would find the other plug, match it up to a light and then plug it in.

Here I am checking inside the light. For example, if there was a light that did not turn on even though it was plugged into the dimmer, I would take the light down and check the insides. If the insides are okay, then I would check the bulb. Also, be careful with the bulb using a piece of fabric when holding it as skin can take the life away from the bulb.

This is the grand master. If you find that no lights are turning on even though you have followed the step by step guide, you may find that the grand masters are not turned on. If the grand masters are not turned up then the lights will not turn on.