Upload
others
View
4
Download
0
Embed Size (px)
Citation preview
Instruction Manual CarPlay
[email protected] car-solutions.com
Car-S
olutio
ns.co
m
INDEX
Specifications
1. Main Spec. ----------------------------------
2. Components---------------------------------
3. Exterior --------------------------------------
Settings ------------------------------------------
Installation
1. Connection ----------------------------------
2. Caution --------------------------------------
2
3 4 5 6
7 8
[email protected] car-solutions.com
Car-S
olutio
ns.co
m
Specification
1. Main spec.
3
1-1. Input Spec. - 1 x USB Input - 1 x Microphone Input - 1 x Real Analog Touch Input 1-2. Output Spec. - 1 x LVDS(HDMI Connector) Output - 1 x Audio L/R (3.5Ф Stereo Jack) Output - 1 x Mono Speaker 1-3. Power Spec. - Input Power : 8VDC ~ 24VDC - Consumption Power : 12Watt, Max
[email protected] car-solutions.com
Car-S
olutio
ns.co
m
Specification
2. Components
4
Interface 1 EA
AUX Cable 1 EA
Power Cable 1 EA
SPEAKER Cable 1 EA
HDMI Cable 1 EA TOUCH Cable 2 EA
Microphone 1 EA
[email protected] car-solutions.com
Car-S
olutio
ns.co
m
Specification
3. Exterior
5 [email protected] car-solutions.com
134.5mm 23mm
82mm
*Touch Connect ① Y- ② X- ③ Y+ ④ X+
① ② ③ ④
*POWER Connect ① ACC ② GND
① ②
Speaker AUX LVDS&UART OUT
Smartphone Connection
Touch Calibration
Microphone In Car
-Solu
tions
.com
Settings
6
1. Press the setting button for 3 seconds. 2. When the above menu appears, press the setting button for 3 seconds.
3. Calibrate the touch screen
[email protected] car-solutions.com
Car-S
olutio
ns.co
m
7
Installation
Connection
Iphone
Screen
Microphone
Screen
Screen
AUX
3.5pie aux cable
Inte
rface
[email protected] car-solutions.com
Car-S
olutio
ns.co
m
8
Caution
• Not possible to switch mode - Check connection of OSD Key pad wire - Check CAN connection • Display wrong size of picture - Check Dip s/w setting • Display black screen in OEM mode - Check connection of LVDS/LCD cable • Not possible to switch to rear screen - Check the packing setting (OSD Menu – option – RearCam-Det)
1. FAQ
• The device must not be installed in where it interferes driving (close to brake pedal, steering wheel, airbag etc.) • LVDS cable must be connected correctly according to the manual • Insulate the end of wire by using electrical tape
• The installation should be done by expert • GU electronic does not take any responsibility for any problem
caused by wrong installation
2. Caution
[email protected] car-solutions.com
Car-S
olutio
ns.co
m