SUBPART A1. C.A.R 21 deals with: (Oct 2010)a) Issue of Certificate of Registrationb) Certification procedures for aircraft and related products and parts.c) Issue of C.A.R Section-2 (Airworthiness).2. Product is defined as:a) An aircraftb) Aircraft enginec) Propellerd) All the above are correct.3. Demonstrate means:a) Comply with C.A.Rb) Meeting a rule, Regulation or requirements.c) Demonstrate to DGCA4. The reports of failure, malfunction, defect or other occurrence shall be made in a form and manner established by DGCA, and in any case:a) Dispatched not later than 72 hours after identification of possible unsafe condition.b) Dispatched not later than 48 hours after identification of possible unsafe condition.c) As in (a) unless exceptional circumstances prevent this.d) As in (b) unless exceptional circumstances prevent this.5. Airworthiness directive is a document:a) Issued or adopted by DGCA.b) It mandates action to be performed on an aircraft to restore as acceptable level of safety and as in (a).c) Issued or adopted by FAAd) It does not mandate action to be performed on an aircraft to restore as acceptable level of safety6. An Airworthiness Directive shall at least contain the following information:a) Identification of affected aircraft and its unsafe conditionb) Action(s) required.c) Compliance time for required action.d) All the above are correctSUBPART B7. An application for TC or RTC shall be made in ______ form.a) CA-30b) CA-31c) CA-32d) CA-33

8. An application for TC of large aeroplanes and large rotorcraft is effective for:a) 2 yearsb) 3 years c) 4 yearsd) 5 years9. An application for TC of other than large aeroplanes and large rotorcraft is effective for:a) 2 yearsb) 3 yearsc) 4 yearsd) 5 years10. An organization applying for TC or RTC shall demonstrate its capability by holdinga) DOAb) POAc) AODd) AOP11. In case where a TC has not been issued or it is clear that TC will not be issued within the time limit specified by DGCA, an applicant may:a) Manufacture the product, part or applianceb) Sign a letter of agreement with DGCA for production of Product.c) File a new application for a TC12. Which of the following extensive changes to TC will require issue of a new TC:a) Designb) Powerc) Thrust d) All the above

13. Which of the following information are included in TC or RTCa) Operating limitations, applicable type certification basis and environmental protection requirementb) Aircraft TC and RTC both include TCDS for noisec) Engine TCDS include record of emission complianced) All the above

14. Once TC and RTC are approved, both are valid for________,a) 6 monthsb) Max. duration of 6 monthsc) Max. duration of 12 monthsd) None of the above

15. Calculate the fees required while applying for a Type Certificate of an aircraft having maximum design take-off weight 5700 kg.a) 20,000/-b) 30,000/-c) 70,000/-d) 80,000/-16. Calculate the fees required while applying for the Type Certificate of helicopter having max. design take-0off weight 5700 kga) 70,000/-b) 77,500/-c) 80,000/-d) 84,000/-17. State the fees required to be paid while applying for TC of propellera) 2,00,000/-b) 50,000/-c) No fees is required for Type Certificate holder

SUBPART D18. CAR 21 subpart D specifies:a) The procedure for approval of changes to TC and RTCb) The Procedure for approval of TC and RTCc) The procedure for Application of STCd) The procedure for issue of C of A, Restricted C of A, Export C of A for newly manufactured aircraft.19. As per CAR 21 subpart D only the following applicant is eligible for the approval of major changes to the type design or TC.a) Any natural or legal personb) TC holderc) Owner of the aircraftd) Operator of the aircraft20. Which of the following form is applicable while applying for Major changes to TC or RTC?a) CA-30b) CA-31c) CA-32d) CA-3321. Which of the following form is applicable while applying for Minor changes to TC or RTC?a) CA-30b) CA-31c) CA-32d) CA-3322. Minor changes to a type design are classified and approved by:a) DGCAb) By an appropriately approved Design organizationc) FAAd) Either (a) or (b)23. An application for changes to TC for a large aeroplane and large rotorcraft is effective for:a) 2 yearsb) 3 yearsc) 4 yearsd) 5years24. An application for changes to TC for other than a large aeroplane and large rotorcraft is effective for:a) 2 yearsb) 3 yearsc) 4 yearsd) 5years25. Applicant for approval of major changes/ Major repair design in aircraft having max. design take-off weight of 1000 kg will be charged;a) 5000/-b) 10,000/-c) 20,000/-26. When TC holder applies for approval of Minor change/ Minor repair design in an aircraft having max. design take-off weight of 1000 kg, he will be charged;a) 2500/-b) As in (a) and 1250/- every additional 1000 kg or part thereof.c) 60,000/-d) None of the aboveSUBPART E27. Which of the following form is required to be duly filled and submitted while applying for the STC:a) CA-30b) CA-31c) CA-32d) CA-3328. STC after approval is valid for the given duration:a) Unlimited durationb) Max. 12 monthsc) 12 monthsd) 1 year29. Applicant for STC for APU will be charged:a) 25,000/-b) 50,000/-c) 2,00,000/-SUBPART F30. An application for agreement of production under CAR 21 Subpart F should be made in the following forma) CA-50b) CA-60c) CA-65d) CA-8031. An approval for agreement of production under CAR 21 Subpart F will granted by DGCA on which of the form mentioned below?a) CA-50b) CA-60c) CA-65d) CA-8032. As per CAR 21 Subpart F, Findings are classified as (Oct 2010)a) Level one, level two, level threeb) Class one class two, class threec) As in (a) and in case of level one finding, the holder of letter of agreement shall demonstrate corrective action to DGCA within a period of 7 working days, extendable upto max. 21 working days.d) As in (b) and in case of Class two finding within three months, extendable upto max. of six months33. The letter of agreement issued under CAR 21 Subpart F is valid for:a) Limited duration not exceeding 6 monthsb) Limited duration not exceeding 12 monthsc) Limited duration not exceeding 18 monthsd) Limited duration not exceeding 24 months34. Applicant for agreement of production organization under CAR 21 Subpart F and having more than fifty and upto 200 employees will be charged:a) 25000/-b) 50000/-c) 100000/-35. The fees for renewal of agreement of production organization under CAR 21 Subpart F is specified as;a) 50% of new agreementb) 25% of new agreementc) 10% of new agreement

SUBPART G36. Application for production organization approval under CAR21 Subpart G should be submitted on a) CA-50b) CA-60c) CA-80Ad) CA-80B37. Mark the correct answerAuthorised Release Certificate Statement of ConformityCertificate of Release to Servicea) DGCA Form 1 DGCA Form 52DGCA Form 53b) DGCA Form 53 DGCA Form 52DGCA Form 1c) DGCA FORM 52 DGCA FORM 53DGCA FORM 1

38. Applicant for Production Organization approval (POA) having fifty employees, under CAR21, Subpart G, will be charged:a) 100000/-b) 50000/-c) 25000/-

39. An approved Production organization should submit to DGCA a Production Organization Exposition providing the following information :a) A statement signed by Accountable managerb) Titles and names of managers accepted by DGCA.c) An organizational chart showing associated chains of responsibility of managersd) All the above

SUBPART H40. Approval of C of A will be granted by DGCA on;a) CA-21b) CA-23c) CA-24d) CA-2541. An application for Restricted C of A should be submitted on;a) CA-21b) CA-23c) CA-24d) CA-2542. An application for C of A should be submitted on;a) CA-21b) CA-23c) CA-24d) CA-2543. C.A.R 21 prescribes the procedure requirements for;(June 2010)a) The issue of certificate of airworthinessb) The issue of restricted C of Ac) The issue of Export C of Ad) The issue of C of A/ Export C of A for new aircraft manufactured in India

44. Certificate of airworthiness to a newly manufactured aircraft in India can be issued, (June 2010)a) If aircraft is registered in the name of any legal personb) As in (a) or its representative may apply for the issue of C of Ac) C of A conforms to the type certificate of FAA/ EASAd) All are correct.

45. Application for the C of A of newly manufactured aircraft shall be made in a manner established by DGCA and shall;(June 2010)a) Indicate the class of airworthiness certificate applied with regards to aircraftb) For an imported aircraft, a statement should be signed by the Exporting Authority that aircraft conforms to a design approved by the authorityc) As in (b), weight and balance report with a loading scheduled) All are correct

46. Mark the correct statement for the duration and continued validity of C of A as per CAR-21; (June 2010)a) C of A shall be issued for the period in accordance with CAR Section 2 (Airworthiness), series F, Part IIIb) As in (a) and aircraft remaining on the Indian registerc) Upon surrender or revocation the certificate shall be returned to DGCAd) All are correctSUBPART I47. An application for a Noise certificate can be made in below mentioned form to DGCA:a) CA-45b) CA-2006-1c) CA-2009-1d) CA-5448. An application for issue of Noise Certificate shall include:a) Operating limitations, applicable type certification basis and environmental protection requirementb) Statement of Conformityc) As in (a) and shall be issued not more than 60 days before presentation of aircraft to DGCAd) As in (b) & shall be issued not more than 30 days before presentation of aircraft to DGCA49. After issue of a Noise Certificate by DGCA, it can be modified bya) An appropriately approved Design organizationb) An appropriately approved Production organizationc) DGCAd) Both (a) and (b) are correct.50. A Noise certificate after approval remain valid for:a) Duration not exceeding 12 monthsb) Unlimited duration c) 1 year51. All the records related to Noise certificate will have to be preserved by DGCA also. These records should contain;a) A copy of certificate including amendmentsb) of airworthiness certificate applied with regards to aircraftc) as in (a) and the record shall be archived for a min retention period of 1 year after leaving the registerd) as in (b) and the record shall be archived for a min retention period of 1 year after leaving the registerSUBPART JA52. Each application for a Design Organization approval under CAR 21 Subpart JA shall be made in following form;a) CA-82Ab) CA-82Bc) CA-80Ad) CA-80B

53. MTCS with respect to CAR 21 Subpart JAa) The terms of approval shall identify type of design work and categories of productb) The function and duties that the organization is approved to perform.c) This part details the procedure for approval of design organization designing parts and appliances or changes thereto.d) Both (a) and (b) are correct54. The design organization approval, as per CAR 21 subpart JA, shall be issued for;a) Limited duration not exceeding 12 monthsb) Limited duration not exceeding 6 monthsc) Limited duration not exceeding 18 monthsd) Limited duration not exceeding 24 months55. When objective evidence is found showing non-compliance of the holder of a design organization approval with the applicable requirement , the findings are classified as;a) Level One, level two and Level threeb) Class one, class two and class three.c) As in (a) and in case of Level one or Level two finding , the design organization approval may be subjected to partial or full suspension or revocation.d) As in (b) and in case of Level one or Level two finding , the design organization approval may be subjected to partial or full suspension or revocation.56. An application for Significant changes to Design Organization approval (DOA) under CAR 21 Subpart JA should be submitted on:a) CA-82Ab) CA-82Bc) CA-182Ad) CA-182B

SUBPART JB57. Each application for a Design Organization approval under CAR 21 Subpart JB shall be made in following form;a) CA-82Ab) CA-82Bc) CA-80Ad) CA-80B58. An application for Significant changes to Design Organization approval (DOA) under CAR 21 Subpart JB should be submitted on:a) CA-82Ab) CA-82Bc) CA-182Ad) CA-182B59. Elimination of damage and/or restoration to an airworthy condition following initial release into service by the manufacture of any product, part or appliance is termed as

a) b) Repairc) Inspectiond) Restoratione) Modification

SUBPART O

60. An application for an ITSO authorization shall be made in the below mentioned form;a) CA-31b) CA-34c) CA-35d) CA-3661. An application for ITSOA for all items except APU, will be charged as :a) 20,000/- per itemb) 30,000/- per itemc) 2,00,000/-SUBPART P62. Under CAR 21 subpart P, Permit to fly can be issued for which of the following purposes?a) Exhibition and air showb) Record breaking, air racing or competitionc) Design organization or Production organization crew trainingd) All the above 63. Mark the correct statementa) Application for permit to fly- CA 22b) Issue/ approval of permit to fly- CA 21c) Application for approval of flight condition CA 2064. A Permit To Fly will be issued for a period of;a) Unlimited durationb) Max 12 yearsc) Max 12 months

SUBPART Q

65. Identification of a product includes;a) Manufacturers nameb) Product designationc) As in(a) and manufacturers serial numberd) All are correct