8/9/2019 camara especiales CNB SD1750NA
1/1
Dome (89.5)
Signal SystemScanning SystemScanning Frequency (H)Scanning
Frequency (V)Image SensorTotal/Effective Pixels No.S/N
RatioResolutionVideo Output LevelLensFocusSync.
SystemSensitivityElectronic ShutterWhite Balance
AGC / BLCInput/Output Connector
Audio (Option)Supplied VoltagePower ConsumptionDimensions
(xH)Weight
NTSC : 525 Lines PAL : 625 Lines2 : 1 Interlace
15.734kHz 15.625kHz59.94Hz 50Hz
1/3 inch SONY Super HAD CCD410K/380K [Normal:270K /250K]
470K/440K[ Normal:320K/2 90K]
More than 48dB550 TV Lines / 480 TV Lines / 380 TV Lines
1.0 Vp-p (75 Ohms, composite)Fixed Lens(f=3.8mm, 6.0mm
Selectable)/ Pin Hole Lens
ManualInternal
0.3 Lux(High) / 0.1 Lux(Normal)1/60~100,000 Sec. 1/50~100,000
Sec.
AutoAuto
Power(Red Jack), Video(Yellow Jack)3 Vp-p (max), 45dB (typ.)
DC 9V ~ 15V (Recommendation DC 12 0.5V)Less than 150mA
89.5 x 63mmApprox. 157g
The image does notappear on the screen.
Check the power source for the monitorand camera and assure that
the voltageand polarity are properly connected andbeing supplied
correctly.
The image on thescreen is dim.
Check if the lens is stained. If dirty,clean the lens with a
soft, clean cloth.Adjust the Back Focus of the lens again.
The camera does notwork properly, thesurface of the cameracase
is hot, and ablack line appears onthe screen.
Check if you have connected the camerato a proper power source
and If there isno problem with the power, turn the unitoff
immediately and seek assistance fromour After Service
department.
The screen blinks a lot. Check if the camera is pointed
towardthe sun or a fluorescent lamp.Adjust the angle or location of
thecamera if too much light is coming intothe screen.
This manual explains the installation and operating method for
the color dome camera. Before installation, make sure you are
familiar with this product's special features and proper operating
technique.
!
SPECIFICATIONS:
DIMENSIONS(mm):USER INFORMATION:
PRECAUTION:
INSTALLATION:Changes in this user manual canbe made without
notice, in order to improve the product quality.COMPOSITION:
CONNECTION:
TROUBLESHOOTING:
CAUTION! TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVECOVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE.REFER
SERVICING TO QUALIFIED SERVICE PERSONNEL.
CAUTIONRISK OF ELECTRIC SHOCK
DO NOT OPEN
All the warnings and instructions of this manual should be
followed.
Keep enough space around the unit for ventilation.Slots and
openings on the monitor should not be blocked.During flashes of
lightning or cracks of thunder, or when the systemis not used for a
long time, unplug the system power supply toprotect the unit from
lightening or power surges.
Do not attempt to service this unit yourself as opening or
removingcovers may you to dangerous voltage or other hazards.
Please referall servicing to qualified service personnel.
Do not place anything on top of the unit that might spill or
fall into it.
To reduce the risk of fire or electric shock, do not expose this
applianceto rain or moisture.
Remove the plug from the outlet before cleaning. Do not use
liquidaerosol detergents. Use water damped cloth for cleaning.
THE GRAPHIC SYMBOLS WITH SUPPLEMENTAL MARKING ARE ON THE
BOTTOMOF THE SYSTEM."WARNING-TO PREVENT FIRE OR SHOCK HAZARD, DO
NOT EXPOSE THE UNITTO RAIN OR MOISTURE"
The lightning flash with arrowhead symbol, within an
equilateraltriangle, is intended to alert the user to the presence
of un-insulated "dangerous voltage" within the product's enclosure
that may be of sufficient magnitude to constitute a risk of
electric shock to persons.The exclamation point within an
equilateral triangle is intended toalert the user to the presence
of important operating and maintenance-(servicing) instructions in
the literature accompanying the appliance.
Explanation of two Symbols
If you have trouble operating your camera, refer to the
following.If the guidelines do not enable you to solve the
problem,contact an authorized technician.
Ceiling
No.
#1
#2
Function
Video OutputPower Input
Terminal Color
YellowRed
Audio Output White (Option)
RecommendablePower Supply
(DC 12V/ Over 0.3A Power Adapter)
# 1
# 2
Video(Yellow)
Power(Red )
Video Output
GND
Power(+)
GND
Insert coin to the side hole andremove the dome cover by twist
coin.
NOTE
Owner's Manual
Dome Camera Guide Pattern
Mounting Screw2 Fixed the camera to a
ceiling using two screws.
1 Stick the guide patternon the wall or ceiling.
3 After fixing it, adjust itspan base and tilt baseproperly.
4 After adjust them, fixedthe dome cover.
3 9
. 0
2 4
. 0
89.5
113.0
Dome Base
Guide Pattern
MountingScrew
Dome Cover
P / N : 3 8 1 0 - 0
0 8 3 A
v e r .
0 6 0 4 E
cameracolor
CCD CameraColorColorDigital DSP
1/3" SONY CCD
LENS .Fixed.Pin Hole
