IKV Fact Sheet

Cable Pulling Compound

The informa�on set forth herein is furnished free of charge and is based on technical data that IKV TRIBOLOGY believes to

be reliable. It is intended for use by persons having technical skill and at their own discre�on and risk. Because condi�ons

of use are outside our control, we make no warran�es, express or implied and assume no liability in connec�on with any

use of this informa�on. Nothing herein is to be taken as a license to operate under or a recommenda�on to infringe any

patents.

T: 01291 691953

sales@ikvlubricants.com

www.ikvlubricants.com

Wire pulling compound, often called cable lube

is designed to ease in pulling electrical wires

through conduit runs.

Our product IKV GEL 1790 reduces the

co-efficient of friction between cables and ducts

during installation and cable pulling operations.

A low coefficient of friction makes cable pulling

easier and safer with less chance for cable

jacket damage from high pulling forces.

IKV-GEL 1790 is a special w ater based

lubricating clear fluid gel that considerably

reduces the coefficient of friction between

plastic or rubber parts and the supports on

which they are mounted to aid assembly and for

smooth low-tension wire and cable pulling. A

low coefficient of friction makes cable pulling

easier and safer with less chance for cable

jacket damage from high pulling forces.

IKV-GEL1790 is designed to minimise dripping

avoiding the risk of streaks or running when

applied. After the water content ‘carrier’ has

evaporated, the product turns into a dry,

translucent and uniform film with the necessary

properties to help ensure the part does not move

further. Once set this film is dry to the touch and

will not attract dust or debris. It also does not

contaminate other surfaces which come into

contact.

IKV-GEL 1790 is easy to handle and apply and

because the material is colourless and non

staining it offers quick and easy clean-up. The low

solids content means less conduit blocking if

additional pulls are required.

IKV-GEL 1790 can be used and is compatible

with plastics, rubbers and metals and is used to

facilitate movement/lower friction and ensure

easier fitting without creating stresses and

stretching within the parts.

IKV-GEL 1790 is best appl ied pure either by

pouring/pumping onto the cable continuously

during the pull or applied using a soft brush,

sponge or other similar applicator. Excess product

or spillages can be removed or cleaned up with

large amounts of water.

IKV-GEL 1790 is designed to ensure maximum

safety for the user: it contains neither solvents nor

petroleum products, it does not release Volatile

Organic Compounds (VOCs) and is non toxic. It is

also non flammable.