BY:Jordan K

Matt M

Adam M

INDEX

• WHY OURS

• Making the robotic arm

• Pictures

WHY OURS!

• Our robotic arm is state of the art. It uses a highly crafted magnetic lift to transfer the duet from point A to point B with the push of only two syringes. It has proved to be accurate in the placing of the do it and does not leave much room for error. There will be no more cut off limbs because the the controls for our robotic arm can be used from a safe distance. We hope you will take a look at buying our arm and hope we will be able to show you what Do IT inc can do for YOU.

Making the Robotic Arm

First we had no idea what we were going to do, first we were going to make a gantry robot then we found out that that idea was to hard so we decided to build a arm robot. We first built the base with a wooden base. Next we built the arm which will pick up the DOIT and move it from point A to point B. Then we attached the syringes and made a control center. After that we just had to make sure every thing was working properly.

We encountered many problems along the way to making our super awesome robotic arm. First we had many problems with building the actual robot we had three different ideas of the blueprint of the robots design. Then when we had the robot built we had trouble turning it from left to right. Then Just as we were ready to present w had major leakage problems. We went through many syringes.

Jordan Sawing the top part of the arm!

The base of the arm and point A and point B.

Adam sanding our Dominos

Jordan getting ready to cutt a shopping cart for an axle

Painting the Arm

Jordan was a little glue Happy!

Matt the good looking one workin hard

Jordan working with toxic chemicals

Finished Project

Good enough to see again