4
Rony Parvej’s EEE Question Bank M.Sc. Admission Test-2014, BUET Admission Test Question of Bangladesh University of Engineering Technology (BUET) Collected from : Tamal Sarkar (RUET’08) & Imam Hasan (DUET’04) Compiled by: Rony Parvej (IUT, EEE’07) Post: M.Sc. in EEE Time: Unknown Full Marks: Unknown Exam Date: 26.09.2014 Venue: BUET 1. Find the voltage across 1resistance in the following circuit: 2. What is the value of (a-b) in the following circuit? 3. Draw the phasor diagram of the following RC circuit: 4. In a Y-connected balanced 3-phase circuit V ph = 208 V, p.f. =0.6, P = 300W. Z ph = ? ( ইমাম হাসান) given line voltage 208V, power, pf 0.6. y-y connection balanced 3phase, find impedance on each phase-math ( তমা) 5. v= 20 sin (ɷt) + 15 sin (2ɷt) 10 sin (3ɷt) i = 6 sin (ɷt+20) + 2sin (ɷt +30) - sin (3ɷt + 60) . Find average power. ( ইমাম হাসান ভাইয়ের কাছ থেয়ক পাওো তেয অযােী) v=a sin (ɷt)+ b sin( 2ɷt) + c sin(3ɷt) i=d cos (ɷt+30)+ e cos (ɷt-30) + f cos (ɷt+120) .Find average power. ( তমায়র কাছ থেয়ক পাওো তেয অযােী)

BUET MSC Admission Test (26.09.2014) Question by Rony Parvej

Embed Size (px)

Citation preview

  • Rony Parvejs EEE Question Bank M.Sc. Admission Test-2014, BUET

    Admission Test Question of Bangladesh University of Engineering Technology (BUET) Collected from : Tamal Sarkar (RUET08) & Imam Hasan (DUET04)

    Compiled by: Rony Parvej (IUT, EEE07) Post: M.Sc. in EEE

    Time: Unknown Full Marks: Unknown

    Exam Date: 26.09.2014 Venue: BUET

    1. Find the voltage across 1 resistance in the following circuit:

    2. What is the value of (a-b) in the following circuit?

    3. Draw the phasor diagram of the following RC circuit:

    4. In a Y-connected balanced 3-phase circuit Vph = 208 V, p.f. =0.6, P = 300W. Zph = ? ( )

    given line voltage 208V, power, pf 0.6. y-y connection balanced 3phase, find impedance on

    each phase-math ( )

    5. v= 20 sin (t) + 15 sin (2t) 10 sin (3t) i = 6 sin (t+20) + 2sin (t +30) - sin (3t + 60) . Find average power.

    ( )

    v=a sin (t)+ b sin( 2t) + c sin(3t) i=d cos (t+30)+ e cos (t-30) + f cos (t+120) .Find average power.

    ( )

  • Rony Parvejs EEE Question Bank M.Sc. Admission Test-2014, BUET 6. Two line currents of an unbalanced 3-phase, 3-wire system are 10090 A and 110-10 A.

    Find the third line current.

    7. A single line diagram indicated by a point, given 6 fault current from primary and secondary

    side. what type of fault to be determined. ( )

    Determine the type of fault. ( )

    8. .

    9. Stevenson Junior (4th ed.) 200 page 8.1

    10. Determine the induction torque in a 400 V, 50 Hz, 4-pole, Y-connected induction motor operating at 2% slip with 240W power being lost in its motor winding.

    11. If VS = sine wave, then draw Vin - Vout transfer curve.

    ( )

    Draw Vin vs Vout transfer curve of an op amp with 5v reference at negative input, sine wave in

    positive input , biasing 12V, at output two zener diodes of 7V and 9V were connected face-to-

    face. ( )

    12. Answer in one word: i) peak demand in summer in BD

    ii) load factor of a base load station

    iii)

    Iv)

    v)

    13. 5 MCQ Questions

    14. Draw the CMOS complex gate logic circuit function on F = A (B + C ) .

  • Rony Parvejs EEE Question Bank M.Sc. Admission Test-2014, BUET 15. 6.8 V Zener diode, VZ =6.8 V , IZ = 5 mA, rZ =20, IZK =0.2 mA. Find output voltage.

    ( )

    Zener diode math with fixed load (a very tough one indeed) with PZ, IZ, IZK, RL. Find output

    voltage. ( )

    16. Find VC , and for common emitter bias.

    17. x(t) = 2 sin ( 400 t ) + 4 cos ( 600 t ). Sampling of 2400 Hz. (a) Find the equation of x(n). (b) Find the period of x(n). (c) Draw the spectrum of x(n).

    18. Signal power = 2 MW, Noise power = 1.95 MW. Find maximum data rate and Shanons

    capacity. [Find maximum delta modulation shanons theorem (300-3300) Hz ]

    19. True- False

    20. x (t) = 1.5 cos (800t) is to be PCM with minimum SQNR of 25dB. How many bytes are required for encoding each having uniform quantization.

    21.

  • Rony Parvejs EEE Question Bank M.Sc. Admission Test-2014, BUET

    22. . B.P lathi (exercise 6.2. 5) ECG math

    23. Draw the block diagram of a optical fibre communication system. What type of technique is widely used in multiplexing and what is the most common wavelength used in optical fiber now

    a days.

    24. a verilog code was given which was actually a Negative edge clock D-FlipFlop. execute