Upload
buianh
View
236
Download
0
Embed Size (px)
Citation preview
Installation Model specific instructions
These instructions are a model specific add-on to the general BoosterPlug installation instructions. The general BoosterPlug installation instructions can be found in the “Downloads” section on the BoosterPlug.com website: http://www.boosterplug.com/shop/cms-downloads.html
For:
• Triumph Tiger 800 (2010-2014)
• Triumph Tiger 800 XC (2010-2014)
• Triumph Tiger 800 XR/XRx/XRt (2015 and up)
• Triumph Tiger 800 XC/XCx/XCa (2015 and up)
Installation Tips • Install the BoosterPlug module as per the general installation papers.
• The pictures below should help you locate the AIT sensor where the BoosterPlug is installed.
• Remove the seat (Yellow circle - Picture 1)
• Remove lower plastic covers on both sides (Yellow circle - Picture 2)
• Loosen upper plastic covers on both sides no need to remove them completely.(Yellow circle - Picture 2)
• Lift the rear end of the tank - make sure you dont scratch the tank against the upper plastic covers - protect the tank with a clean
rag (Yellow circle - Picture 3)
• The red circle will show you the location of the AIT sensor
Pictures