BMW ISSS for real ICOM configuration

manual

Note:

Minimum Computer Hardware Config: Dual Core 2.0G CPU/ 4G RAM/250G

HardDisk/ Win xp SP3 professional or 7 64bit Ultimate version

Recommend Computer Hardware Config: Intel I3 or I5 CPU/8G RAM/250G

7200RPM Harddisk/ Win 7 64bit Ultimate Version

1. Copy the ISSS all files to Harddisk, Unpack ISSS from archives.

2. Install VMware Workstation 8, run and select Virtual Network Editor.

www.obd2express.co.uk

3. Configure network exactlly as on picture. At green ellipse marked place

for VMnet0 select network adapter which will be used for connection with

ICOM

4. Open ISID or ISSS virtual machine. If you have Win x64 and host RAM

more then 4Gb, then you can set ISID memory size from 1536Mb to 2048Mb.

ISSS can process Exx with 2048Mb instead of 4096Mb, but will show you

warnings. Don't use other values since this will cause failures.

5. Open VM properties and check Network Adapter set to VMnet2, close and

boot.

www.obd2express.co.uk

6. When asked, select "I moved it".

www.obd2express.co.uk

7. Wait until VM boots and ISTA icon gets active.

www.obd2express.co.uk

8. Connect ICOM using network cable to PC, then connect ICOM to car, wait

about minute or two.

9. Click right mouse button over connection icon on the right bottom VM

window corner and select "Settings...".

www.obd2express.co.uk

10. Change Network connection type to "Bridged" then press "Ok".

www.obd2express.co.uk

11. Connection icon will change to inactive state and after some time

gets back to active. Wait 1-2 minutes, then start ISTA via one-double

left mouse button click over ISTA-D or ISTA-P icon in WSM interface.

www.obd2express.co.uk

12. For ISID select "Identification", for ISSS select "Create new

session".

www.obd2express.co.uk

13. Next for ISID click on "Read out vehicle data" then "Ok", for ISSS

click "Continue".

www.obd2express.co.uk

14. After some time in ISID or ISSS "Connection manager" list should

appear your ICOM. Select it and press "Set up connection" or "Connect".

www.obd2express.co.uk

Note: By default supported only chinese clone ICOM with corresponding

firmware version.

www.obd2express.co.uk