2
RF SECTION The RF section is the part of the cell-phone circuit is also known as RF Transceiver. It is the section that transmit and receive certain frequency to a network and synchronize to other phone. The RF - A radio section is based on two main Circuits. 1 Transmitter / TX 2 Reciever / RX A simple mobile phone uses these two circuits to correspond to an other mobile phone. A Transmitter is a circuit or device which is used to transmit radio signals in the air. Reciever is simply like radios which are used to recieve transmissions(Radiation) which is spread in the air by any transmitter on a specific frequency. POWER MANAGEMENT A power management section in mobile phones is designed to handle energy matters that is consumed in mobile phones. There are two main sub sections in a single power section ANALOG BASEBAND VOICEBAND CODEC This section converts andprocess the analog to digital (A/D) signals and digital to analog signals (D/A).

Block Diagram Rev

  • Upload
    bing

  • View
    214

  • Download
    0

Embed Size (px)

Citation preview

RF SECTIONThe RF section is the part of the cell-phone circuit is also known as RF Transceiver.It is the section that transmit and receive certain frequency to a network and synchronize to other phone.

The RF - A radio section is based on two main Circuits.1 Transmitter/ TX2 Reciever/ RXA simple mobile phone uses these two circuits to correspond to an other mobile phone. A Transmitter is a circuit or device which is used to transmit radio signals in the air.Reciever is simply like radios which are used to recieve transmissions(Radiation) which is spread in the air by any transmitter on a specific frequency.POWER MANAGEMENTA power management section in mobile phones is designed to handle energy matters that is consumed in mobile phones. There are two main sub sections in a single power section

ANALOG BASEBAND VOICEBAND CODECThis section converts andprocessthe analog to digital (A/D) signals and digital to analog signals (D/A).

CPUCPU( Centeral Processing Unit) The Central Processing Unit (CPU) is responsible for interpreting and executing most of the commands from the users interface. It is often called the "brains" of the microprocessor, central processor, "the brains of thecomputer"

CHARGING SECTIONThe Charging section is based on a charging IC which takes power from an external source and gives it to battery to make it again power up when it is exhausted. this section uses convertibly 6.4 V from an external battery charger and regulates it to 5.8V wile giving it to battery.BATTERYUse as a source of power

SERVICE FORMDIAGNOSIS:ACTION TAKEN: