Upload
southernbellev
View
227
Download
0
Embed Size (px)
Citation preview
8/3/2019 Black & Decker Power Inverter Manual
1/6
VEHICLE PO W ER SYSTEM
POW ER IN V ERTER2 0 0 / 4 0 0 / 7 5 0 WATT
VEC1045BD / VEC1046BD / VEC1047BD
USER S M AN UAL& WARRAN TY IN FORM ATIO N
TO REDUCE THE RISK OF INJURY, USER MUST READ AND UNDERSTANDTHIS INSTRUCTIONAL MANUAL. THIS MANUAL CONTAIN S IMPORTAN TINFORMATION REGARDING THE OPERATION AN D WARRAN TY OF THISPRODUCT. PLEASE RETAIN FOR FUTURE REFERENCE.
www.vectormfg.com
4 1 4 0 S . W . 3 0 t h A v e . , F t . L a u d e r d a l e , F L 3 3 3 1 2
T o l l F r e e : ( 8 0 0 ) 6 1 8 - 5 1 7 8
8
Fault Protection Code and Troubleshooting Guide
INVERTER POWER SWITCH TURNED ON
SPECIFICATIO NS
Pow er Inverter Model VEC1045BD VEC1046BD VEC1047BD
Maximum Continuous Power: 200 watts 400 watts 750 watts
Surge Capacity: 400 watts 800 watts 1500 watts
Input Voltage: 12.8 volts
Output Voltage: Approx. 115 volt AC RMS 60 Hz
Low Voltage Alarm: 11 volts DC 0.3 volt DC
Low Voltage Shutdown: 10.5 volts DC 0.3 volt DC
Thermal Shutdown: Automatic
Wave Form: Modified Sine Wave (MSW)
O utput Connection: N orth American Standard Receptacles
Input Fuses: Internal
Input Cables: Battery cable with ring connector
Additional Protection: Overload, over voltage, overheating
Trouble/ Indication Possible Cause Suggested Remedy
No AC output DC input is out of range Check battery voltage.(red LED lit
Excessive load Turn unit off. Reduce the load,thermal shutdown wait for the inverter to cool
down, then turn the unit onagain.
No AC output Fuse(s) open Check DC input fuse(s) ingreen LED not lit vehicle. Replace the fuse with
one of the same type and ratingif necessary.
Low battery alarm Low battery voltage Recharge battery. Remove
sounds continuously load from the inverter whilerecharging battery.
Bad connection or wiring Tighten all DC connections.
Motorized power tool Excessive start-up load If appliance does not start,will not start appliance is drawing
excessive voltage andwill not work with inverter.
Motorized power tool Purely inductive load Make the load not purelydoes not operate at inductive. Operate ancorrect speed incandescent lamp at the
same time as motor.
Television/ Radio Snow in picture, Keep inverter and antennainterference buzzing sound distant from each other. Use
shielded antenna. Connectantenna to amplifier.
VEC1045_46_47_BD_Manual 4/28/05 5:16 PM Page 8
8/3/2019 Black & Decker Power Inverter Manual
2/6
8/3/2019 Black & Decker Power Inverter Manual
3/6
8/3/2019 Black & Decker Power Inverter Manual
4/6
8/3/2019 Black & Decker Power Inverter Manual
5/6
8/3/2019 Black & Decker Power Inverter Manual
6/6