4
BILL OF QUANTITIES FOR THE PROPOSED INTERIOR WORK AT CANARA BANK – DHARAPURAM BRANCH. S.No DESCRIPTION QTY RATE UNIT AMOUNT INTERIOR WORKS 01. Supplying and fixing of Gypsum board panel false ceiling using galvanized sections for hanging and holding the gypsum board panels of 12mmtk with approved design 5”ht cornice works alround duly painted with three coats of plastic emulsion paint after necessary Pattiworks. Provisions are to be made for fixing of A.C.Grills, light fittings as per consultants instructions including making holes and to assist in fixing the same etc., 1400 Sft Sft 02. Dismantling the Existing partition and providing full height partitions of height 10’0” made of 3’x2” salwood frame work 170 Sft Sft

Bill of Quantities for the Proposed Interior Work

Embed Size (px)

DESCRIPTION

boq

Citation preview

Page 1: Bill of Quantities for the Proposed Interior Work

BILL OF QUANTITIES FOR THE PROPOSED INTERIOR WORK AT CANARA BANK – DHARAPURAM BRANCH.

S.No DESCRIPTION QTY RATE UNIT AMOUNT

INTERIOR WORKS

01. Supplying and fixing of Gypsum board panel false ceiling using galvanized sections for hanging and holding the gypsum board panels of 12mmtk with approved design 5”ht cornice works alround duly painted with three coats of plastic emulsion paint after necessary Pattiworks. Provisions are to be made for fixing of A.C.Grills, light fittings as per consultants instructions including making holes and to assist in fixing the same etc.,

1400 Sft Sft

Page 2: Bill of Quantities for the Proposed Interior Work

02. Dismantling the Existing partition and providing full height partitions of height 10’0” made of 3’x2” salwood frame work finished with 2 coats of termite resistant coating (to be approved by architect) with vertical member at 10’6”, level 8’0” level 4’0” level & floor level. The frame work to be cladded on both sides with 9mm thick marine plywood and finished with 1 mm thick decorative laminate. Front portion with 5mm tk glass 2’0” Ht. The partition to be provided with TW skirting of size 3” x ¾” on both sides and finished to desired wood effect by application of melamine polish after initial surface preparation. with all fixing arrangements, locks and hardwares etc complete. (Appraiser)

170 Sft Sft

Page 3: Bill of Quantities for the Proposed Interior Work

03. Dismantling the existing partition and Supplying and fixing of side partition for Audit/Inspection room & Power Room using aluminimum anodized section frame work with top, middle and bottom portion with marine plywood particle board (9mm tk) and finished with 1mm tk. Decorative laminate, with all fixing arrangements, EPDM rubber gaskets locks and hardwares etc complete.

160 Sft Sft

04. Low Height StorageLow height storage made out of 19mm marine plywood particle board for top, bottom.sides, shutter and shelves with top finished with 1mm tk. laminate sheet, inner surface to be with 2 coats of enamel paint.

Size 5’3’’x1’3’’x 2’9”(Officer Cabin/Inspector cabin)

40 Sft Sft