BIKINI TOP INSTALLATION INSTRUCTIONS 1. Install windshield support brackets under windshield latches (very important-these support your upper windshield frame). 2. Attach upper top latches to bikini header bow with supplied screws. 3. Align post pins and latch the header bow to the windshield frame. (see picture #3)

4. The alignment straps have loops sewn in for aligning the top bows. Fit the dog leg bow through front loops as show in pictures #4-5.

5. Next install the bow on the pivot post. Be sure to put on a plastic washer first. Next the rear bow fits through rear loops. Now install this bow onto the pivot post after second washer. Finally, secure it with the top frame clip. 6. Bring the straps to the rear of the car. Feed each strap through the strap-loop on rear inside of car (see picture #5). Feed the strap from the bottom up through to the buckle.

7. Pull top cover over the bows and straps, pull the top toward rear of car behind the buckle, feed strap through buckle. (The first time is easier with another person). Pull the top and strap at same time to make adjustments for correct tension. (see picture #7).