BEC  7800TNR2  Quick  Start  Guide   Page  1    

BEC 7800TNR2

802.11B/G/N Multi-Service Gateway Quick Start Guide

BEC  7800TNR2  Quick  Start  Guide   Page  2    

Chapter 1: Installing the Router Package Contents • BEC 7800R2 802.11n ADSL2+ Firewall Router • Two 2dBi detachable antennas • Ethernet (RJ-45) cable • RJ-11 ADSL/ telephone cable • Power adapter • Splitter / Micro-filter (Optional)

 

BEC  7800TNR2  Quick  Start  Guide   Page  3    

Device  Description  

The  Front  LEDs  

 

  LED   Meaning  1   Internet   Lit red when WAN port fails to

get IP address. Lit green when WAN port gets IP address successfully. Unlit when the device is in bridge mode or WAN connection is absent.  

2   DSL   Lit green when the device is successfully connected to an ADSL DSLAM. (“line sync”)  

3   WPS   Flash green when WPS configuration is in progress. Unlit when WPS fails.  

4   Wireless   Lit green when a wireless connection is established. Unlit when wireless is disabled.  

5   Ethernet  Port  1X-­‐4X  (RJ45)   Lit green when successfully connected to an Ethernet device. Blinking when data is being transmitted / received.  

6   Power   When the system is ready, it will be lit green. Lit red when the device fails to boot or when the device is in emergency mode  

 

   

BEC  7800TNR2  Quick  Start  Guide   Page  4    

The  Rear  Ports  

 

  Port   Meaning  1   Power  Switch   Power ON/OFF switch

 2   Power   Connect it with the supplied

power adapter  

3   Reset   Press  for  more  than  5  seconds  to  restore  the  device  to  its  factory  default  mode.  

4   WPS   Push WPS button to trigger Wi-Fi Protected Setup function.  

5   Ethernet   Connect  your  computer  to  a  LAN  port  using  the  included  Ethernet  cable  (with  RJ-­‐45  cable).  

6   DSL   Connect  the  supplied  RJ-­‐11  cable  to  this  port  when  connecting  to  the  ADSL/telephone  network.  

7   Wireless  Antenna   Connect the detachable antenna for wireless connection.

 

   

BEC  7800TNR2  Quick  Start  Guide   Page  5    

Hardware  Installation  

 

 

BEC  7800TNR2  Quick  Start  Guide   Page  6    

 

   

BEC  7800TNR2  Quick  Start  Guide   Page  7    

Configuration  via  Web  Interface  

Open  your  web  browser,  enter  the  IP  address  of  your  router,  which  by  default  is  192.168.1.254  and  click  Go  or  press  'Enter'  key  on  the  keyboard.    A  login  prompt  window  will  appear.    The  default  root  username  and  password  are  "admin"  and  "admin"  respectively.  

 

Congratulations!    You  are  now  successfully  logged  into  the  BEC  7800TNR2.  

If  the  authentication  succeeds,  the  Status  page  below  will  appear  on  the  screen.  

 

BEC  7800TNR2  Quick  Start  Guide   Page  8