Faculty of Mechanical and Manufacturing Engineering BDA10703 Technical Drawing & CAD

Session 14/15 Semester I

Assignment 3

1 | P a g e

Sectional View

Draw the front, top and right side views. Complete the front view as a full section view. Dimension excluded.

Draw the front, top and right side views. Complete the front view as a half section view and top view as full section view. Dimension excluded.

Draw the front and top views. Create an offset section view. Dimension excluded.

Draw the front view. Create an aligned section view on right side view using the convention of revolution. Dimension excluded.

Figure 1 Figure 2

Figure 3

Figure 4

Faculty of Mechanical and Manufacturing Engineering BDA10703 Technical Drawing & CAD

Session 14/15 Semester I

Assignment 3

2 | P a g e

Instruction:

1. Unit: mm

2. Due date: Week 8, 2:30 PM

3. Total marks: Five (5)

4. Assessment and marking scheme as attached.

Assessment and marking scheme:

No. Criteria Marks

1 Complete figures 2.5 2.0 1.5 1.0

4 - figures 3- figures 2 - figures 1 - figures

2 Complete and correct section line 1.5 1.0 0.5

Good Moderate Poor

3 Proper cutting plane line 0.5 0

Yes No

4 On-time delivery 0.5 0

Yes No