2
u u u The information contained in this document is subject to change without notice. BASYS EFX-3XX Series S.S. — Rev. 0 (06/11) This space for Architect/Engineer approval Job Name Date Model Specified Quantity Variations Specified Customer/Wholesaler Contractor Architect B u y A m e r i c a n A c t C o m p l i a n t Series Capacitance Faucet u u u u BASYS Spec Language Sloan BASYS Model No. EFX-3___.____.______ Capacitance Sensor Activated Electronic Handwashing Faucet for pre-tempered or hot/cold water supplies. Solenoid valve housed in removable carrier that closes water supply upon removal, eliminating need to access control stops. Solenoid carrier includes mesh filter for easy access and service without disconnecting the supply lines. Thermostatic mixer ordered separately to comply with ASSE 1070 requirements. The product shall be tested and certified to industry standards: ASME A112.18.1M, CSA B125.1, California Health and Safety Code 116875 (AB1953-2006), and Vermont Bill S.152. This product meets ADA ANSI/ICC A117.1 requirements. Description Battery powered, sensor activated, electronic, chrome plated die cast body, pedestal hand washing faucet for pre-tempered or hot and cold water operation. Flow Rates £ 0.5 gpm/1.9 Lpm Multi-Lam Spray £ 1.5 gpm/5.7 Lpm Aerated Stream £ 1.5 gpm/5.7 Lpm Laminar Stream Specifications Battery Powered, Capacitance Sensing, Electronic, Chrome Plated Die Cast Body, Hand Washing Faucet with the following features: Modular construction One tool service Solenoid housed in removable carrier that includes supply strainer Integral water supply shut off Supply strainer serviceable from above deck Vandal resistant spray insert, key housed inside faucet body All electronics sealed to IP-67 Gold plated electrical contacts Above deck individual diagnostic indicators for battery life, solenoid condition, and power-up mode Automatically selects pre-set time-out based on flow rate Capacitance sensing eliminates potential vandal point Flexible, high pressure supply hoses, 3/8” compression connections Bi-stable magnetic solenoid Four (4) “AA” alkaline batteries Single hole installation (pedestal) Includes all mounting hardware Turbine power option Line powered using a variety of volatage adapters Batteries act as a backup in line powered application Thermostatic, below deck for ASSE 1070 compliance Model Creation Guide Options £ EAF-23 Splitter £ EAF-24-A 11-13/16” Extension Cable £ EAF-25-A 47-1/4” Extension Cable £ EAF-17-A 126” Extension Cable Special Finish £ PVDSF Satin (Chrome) Finish Warranty 3 year (limited) EFX-350.010.0000 Shown EFX-3X0-X1X-0XX0 Body Type Power Crown . Mix Sensing Flow Rate . Battery Type Base Plate Adapters Drain Pop- Up 0 £ Hardwire Standard . £ None £ 0.5 gpm Multi-Lam . Alkaline £ None £ None No 1 . £ Below Deck Mechanical Capacitance . £ 4” £ Plug-In 2 . £ Below Deck Thermostatic £ 1.5 gpm Aerated . £ 8” 3 Pedestal . £ 1.5 gpm Laminar . 4 . . £ Box Mount 5 £ Battery . . 8 £ Turbine . . EFX 3 X 0 . X 1 X . 0 X X 0 BASYS Not intended for installation on a metal sink or deck (i.e. stainless steel or cast iron)

BASYS Series Capacitance Faucet

  • Upload
    others

  • View
    5

  • Download
    0

Embed Size (px)

Citation preview

Page 1: BASYS Series Capacitance Faucet

u

u

u

The information contained in this document is subject to change without notice.BASYS™ EFX-3XX Series S.S. — Rev. 0 (06/11)

This space for Architect/Engineer approval

Job Name Date

Model Specified Quantity

Variations Specified

Customer/Wholesaler

Contractor

Architect

Buy

American A

ct •

• C

ompliant

Series Capacitance Faucet

u

u

u

u

BASYS Spec LanguageSloan BASYS Model No. EFX-3___.____.______ CapacitanceSensor Activated Electronic Handwashing Faucet for pre-temperedor hot/cold water supplies. Solenoid valve housed in removablecarrier that closes water supply upon removal, eliminating need toaccess control stops. Solenoid carrier includes mesh filter for easyaccess and service without disconnecting the supply lines.Thermostatic mixer ordered separately to comply with ASSE 1070requirements. The product shall be tested and certified to industrystandards: ASME A112.18.1M, CSA B125.1, California Health andSafety Code 116875 (AB1953-2006), and Vermont Bill S.152. Thisproduct meets ADA ANSI/ICC A117.1 requirements.

DescriptionBattery powered, sensor activated, electronic, chrome plated die cast body, pedestal handwashing faucet for pre-tempered or hot and cold water operation.

Flow Rates£ 0.5 gpm/1.9 Lpm Multi-Lam Spray£ 1.5 gpm/5.7 Lpm Aerated Stream£ 1.5 gpm/5.7 Lpm Laminar Stream

SpecificationsBattery Powered, Capacitance Sensing, Electronic, Chrome Plated Die Cast Body, Hand WashingFaucet with the following features:• Modular construction• One tool service• Solenoid housed in removable carrier that includes supply strainer• Integral water supply shut off• Supply strainer serviceable from above deck• Vandal resistant spray insert, key housed inside faucet body• All electronics sealed to IP-67• Gold plated electrical contacts• Above deck individual diagnostic indicators for battery life, solenoid condition, and power-upmode

• Automatically selects pre-set time-out based on flow rate• Capacitance sensing eliminates potential vandal point• Flexible, high pressure supply hoses, 3/8” compression connections• Bi-stable magnetic solenoid• Four (4) “AA” alkaline batteries• Single hole installation (pedestal)• Includes all mounting hardware• Turbine power option• Line powered using a variety of volatage adapters• Batteries act as a backup in line powered application• Thermostatic, below deck for ASSE 1070 compliance

Model Creation Guide

Options£ EAF-23 Splitter£ EAF-24-A 11-13/16” Extension Cable£ EAF-25-A 47-1/4” Extension Cable£ EAF-17-A 126” Extension Cable

Special Finish

£ PVDSF Satin (Chrome) Finish

Warranty3 year (limited)

EFX-350.010.0000 Shown

EFX-3X0-X1X-0XX0

BodyType Power Crown

.

Mix Sensing Flow Rate

.

BatteryType

BasePlate Adapters

Drain Pop-Up

0 – £ Hardwire Standard . £ None –£ 0.5 gpmMulti-Lam

. Alkaline £ None £ None No

1 – – – .£ Below

DeckMechanical

Capacitance – . – £ 4” £ Plug-In –

2 – – – .£ Below

DeckThermostatic

–£ 1.5 gpmAerated

. – £ 8” – –

3 Pedestal – – . – –£ 1.5 gpmLaminar

. – – – –

4 – – – . – – – . – –£ BoxMount

5 – £ Battery – . – – – . – – – –

8 – £ Turbine – . – – – . – – – –

EFX 3 X 0 . X 1 X . 0 X X 0

BASYS™

Not intended for installationon a metal sink or deck (i.e.stainless steel or cast iron)

Page 2: BASYS Series Capacitance Faucet

SLOAN VALVE COMPANY • 10500 SEYMOUR AVENUE • FRANKLIN PARK, IL 60131Phone: 1-800-9-VALVE-9 or 1-847-671-4300 • Fax: 1-800-447-8329 or 1-847-671-4380 • www.sloanvalve.com

Copyright © 2011 Sloan Valve Company BASYS™ EFX-3XX Series S.S. — Rev. 0 (06/11)

1. A continuous electric field is emitted andmonitored by the faucet system.

2. As the user’s hands enter the effective rangethe sensor activates the solenoid valve allowingtempered water to flow from the faucet. Water will flow until the hands are removed or until the faucet reached its automatic timeout setting.

3. When hands are moved away from the EFX faucet, the capacitive sensor deactivatesthe solenoid valve, shutting off the water flow.The system automatically resets and is readyfor the next user.

u

u Optional Voltage Adapter120 VAC – 50/60 Hz, 6 VDC

Automatic Time Out AdjustmentSettings10 seconds — The Faucet Time outSetting determines the maximumtime the faucet will run uponcontinuous detection. The EFXFaucet is factory set at 10 secondtime out at 1.5 gpm and 30 secondtime out at 0.5 gpm. Consult factoryfor time out settings to meetindividual application requirements.

Max. Distance Control Module maybe installed from SpoutWith Standard Cable: 30” (762 mm)

u

u

SPOUT

1” (25 mm) MIN. DIA. REQUIRED

3/8” (10 mm) SUPPLY TUBE (BY OTHERS)

OPTIONAL ADAPTER

MOUNTING HARDWARE

BELOW DECK THERMOSTATIC MIXING VALVE

BELOW DECK MECHANICAL MIXING VALVE SHOWN

INSTALLED

3/8” (10 mm) COMPRESSION STOPS (BY OTHERS)

HOT SUPPLY COLD SUPPLY

SPOUT

TRIM PLATE

1” (25 mm) MIN. DIA. REQUIRED

BELOW DECK THERMOSTATIC MIXING VALVE

OPTIONAL ADAPTER

OPTIONAL ADAPTER

MOUNTING HARDWARE

3/8” (10 mm) SUPPLY TUBE(BY OTHERS)

3/8” (10 mm) SUPPLY TUBE (BY OTHERS)

HOT SUPPLYBELOW DECK MECHANICAL

MIXING VALVE SHOWN INSTALLED

BELOW DECK MECHANICAL MIXING VALVE SHOWN

INSTALLED

3/8” (10 mm) COMPRESSION STOPS (BY OTHERS)

COLD SUPPLYHOT

SUPPLY

3/8” (10 mm) COMPRESSION STOPS (BY OTHERS)

COLD SUPPLY

BELOW DECK THERMOSTATIC MIXING VALVE

CONTROL MODULE

CONTROL MODULE

CONTROL MODULE

SPOUT

MOUNTING HARDWARE

1” (25 mm) MIN. DIA. REQUIRED

ROUGH-IN DIAGRAM

u

Control Circuit6 VDC Adjustable Range Time OutSettings, Modular Plugs andTroubleshooting LED Indicators.

Battery Life3-years under worst case conditionsof 8,000 cycles per month and highwater pressure. Optional powerharvesting may extend service life ofbatteries to equal the shelf life.

Sensor RangeDynamically Adjusted Up To Max. 3”from Any Faucet Surface

Solenoid ValveFiltered Solenoid Valve withServiceable Strainer Filter

2”(51 mm)

2.25”(57 mm)

42°

4”(106 mm)

1”(31 mm)

2.5”(63 mm)

5”(124 mm)

2”(46 mm)

ELECTRICAL SPECIFICATIONS

u

u

DescriptionBattery powered, sensor activated, electronic, chrome plated die cast body, pedestalhand washing faucet for pre-tempered or hot and cold water operation.

Flow Rates£ 0.5 gpm/1.9 Lpm Multi-Lam Spray£ 1.5 gpm/5.7 Lpm Aerated Stream£ 1.5 gpm/5.7 Lpm Laminar Stream

EFX-3X0-X1X-0XX0DIMENSIONS

OPERATION

EFX Faucet with Below Deck Thermostatic for Hot and Cold Water Supply

EFX Faucet with Below Deck Thermostatic for Hotand Cold Water Supply (shown with 4” Trim Plate)

u

u

When the EFX Series faucet is installed on asink that has three (3) hole punchings, a BasePlate should be used. Base Plates should bespecified at time of order.EFX-20 – 4” CentersetEFX-26 – 8” Centerset

2”(51 mm)

2.25”(57 mm)

42°

4”(106 mm)

1”(31 mm)

2.5”(63 mm)

5”(124 mm)

2”(46 mm)

Not intended for installationon a metal sink or deck (i.e.stainless steel or cast iron)