Upload
vungoc
View
216
Download
2
Embed Size (px)
Citation preview
AUDIO
AXI 22 AT D2 INPUT, 2 OUTPUT DANTE AUDIO INTERFACE
DECORATOR-STYLE WALLPLATE
The Extron AXI 22 AT D is a single-gang decorator-
style Dante® audio interface for integrating two mic/
line sources onto a Dante-enabled audio system. It also
includes two line outputs on the back for routing Dante
channels to an amplifier, or an optional wallplate with
XLR or RCA outputs. The AXI 22 AT D interfaces with
Extron and other Dante-equipped audio devices over
a standard local area network, and can be powered
through PoE.
A Two mic/line inputs on XLR connectors for transmitting audio to a Dante® network
A Two line outputs on a rear panel captive screw connector receive audio from a Dante network
A Dante audio networking provides a wide range of expansion capabilities
A Studio grade 24-bit analog-to-digital and digital-to-analog converters selectable up to 96 kHz
A Input gain and phantom power controls located behind cover plate
A Optional output wallplates for XLR or RCA connectivity
A Power over Ethernet - PoE
A Mounts in an included single-gang decorator-style wallplate
DESCRIPTIONDESCRIPTION
For complete specifications, please go to www.extron.comSpecifications are subject to change without notice.
AUDIO
Gain Unbalanced output: -6 dB, balanced output: 0 dBFrequency response 20 Hz to 20 kHz, ±0.3 dBTHD + Noise <0.01% @ 1 kHz at maximum levelS/NAnalog In to Digital Out >95 dB, 20 Hz to 20 kHz, at full-scale output
(unweighted)Digital In to Analog Out >95 dB, 20 Hz to 20 kHz, at maximum balanced output
(unweighted)Crosstalk <-90 dB @ 1 kHz, fully loaded
AUDIO INPUT
Number/signal type 2 mono mic/line, balanced/unbalancedImpedance >10k ohms, balanced/unbalancedNominal level +4 dBu when level is set to 0 dB gain, adjustable from
-60 dBu to +4 dBuMaximum level >+21 dBu (at rated THD + N) when input gain is set to 0 dBEquivalent input noise <-120 dBV (1 µVrms) at 45 dB gainInput gain adjustment 0 dB to +45 dB, 5 dB steps, adjustable per inputMic phantom power +48 VDC ±10%, can be switched on or off per input
AUDIO OUTPUT
Number/signal type 2 mono (or 1 stereo), balanced/unbalancedNominal level -10 dBV (316 mV) or +4 dBu (1.23 V)Maximum level (Hi-Z) >+15 dBu balanced or >+9 dBu unbalanced
AT PORTS — AUDIO TRANSPORT
Transmission DanteAudio format Uncompressed, 24-bit, selectable at 44.1, 48, 88.2, or
96 kHzLatency Deterministic, based on user selection: 1.0 ms (default),
2.0 ms, 5.0 ms
GENERAL
Power input requirements 12 VDC or Power over Ethernet (PoE 802.3at)Power supply (optional) External
Input: 100-240 VAC, 50-60 Hz Output: 12 VDC, 1 A, 12 watts
Power consumptionDevice 4.5 wattsDevice and power supply 5.9 wattsWarranty 3 years parts and labor
Model Version Description Part numberAXI 22 AT D 2 In, 2 Out Expansion Interface - Decorator - Blk 60-1517-02AXI 22 AT D 2 In, 2 Out Expansion Interface - Decorator - Wht 60-1517-03
WORLDWIDE SALES OFFICES
www.extron.com
Anaheim • Rale igh • S i l icon Val ley • Dal las • New York • Washington, DC • Toronto • Mexico City • Par is • London
Frankfur t • Madr id • Stockholm • Amersfoor t • Moscow • Dubai • Johannesburg • Tel Av iv • Sydney • Melbourne
Bangalore • Mumbai • New Delh i • S ingapore • Seoul • Shanghai • Bei j ing • Hong Kong • Tokyo
APPLICATION DIAGRAM
01-201868-2828-01REV. A4Letter - English - NP© 2018 Extron Electronics. All rights reserved. All trademarks mentioned are the property of their respective owners. Prices and specifications subject to change without notice.
100-240V ~ 0.7A MAX
50/60 Hz LANEXP
RS-232
Tx Rx G
RESET
5 6 7 8
1 2 3 4 8
4 1
1 2 3 4 5 G 61 2 3 4
7 8 9 10 G
11 12 13 14 15 G 16 17 18 19 20 G
2 3 4
5 6 7 8
9 10
11 127
3
6
2
5
1
MIC
/LIN
E IN
PU
TS
OU
TP
UT
S
DIG
ITA
L I/
O
RE
MO
TE
AT
DMP 128 C AT 100-240V 0.7A MAX
LAN
DMP 128 Plus AT
INP
UT
S
RxTx G
RS-232
+S+V -S G
GIN
1
O1O2 GIN
2
O1O2 GIN
3
O1O2 GIN
4
O1O2 GIN
5
O1O2 GIN
6
O1O2 GIN
7
O1O2 GIN
8
O1O2
5 6 7 811 12
1 2 3 49 10
1 2 3 4 5 6 7 8
I/O
OU
TP
UT
S
DM
P E
XP
AC
P
REM
OTE
USB AUDIO RESET
1 (SEC) (PRI)2 3 4
AT
OUTPUT 1
OUTPUT 2
21
3
21
3
INPUT 1
INPUT 2
12
3
12
3
INPUT 1
INPUT 2
12
3
12
3
Extron DMP 128 Plus AT Digital Matrix Processor
DanteNetwork
Extron AXI 22 AT DAudio Expansion Interface
Extron AXI 22 AT DAudio Expansion Interface
Extron WPD 102 XLRMPass-ThroughWallplate
SPECIFICATIONS
The Extron AXI 22 AT D is a single-gang decorator-style audio interface for integrating two mic/line sources onto a Dante®-enabled audio system. It features two XLR audio inputs and switchable 48 volt phantom power for connecting and powering condenser microphones, plus gain controls for each input. The AXI 22 AT D also features two line outputs on the back for routing any two channels from the Dante network to the analog input of a destination device, or connecting to an optional secondary wallplate with two XLR or RCA outputs. The AXI 22 AT D interfaces with any Dante-equipped audio device, such as an Extron DMP 128 Plus AT, over a standard local area network, and can be powered through PoE. This allows a single network cable connection for bidirectional audio and power from a central equipment rack.
KEY FEATURES
A Two mic/line inputs on XLR connectors for transmitting audio to a Dante network – Each input includes selectable 48 volt phantom power and a rotary, detented gain control.
A Two line outputs on rear panel captive screw connectors receive audio from a Dante network – The line outputs can be used for routing any two audio channels from the Dante network to an amplifier, an ALS - assistive listening system, or connecting to an optional secondary wallplate with two XLR or RCA outputs.
A Dante audio networking provides a wide range of expansion capabilities – Dante-equipped audio products, including the AXI 22 AT D, provide scalability for creating larger audio systems over a local area network using standard Internet protocols.
A Studio grade 24-bit analog-to-digital and digital-to-analog converters with selectable sample rates up to 96 kHz – Professional converters fully preserve the integrity of the original audio signal, with selectable sampling rates via Dante Controller.
A Input gain and phantom power controls located behind cover plate – A removable cover plate on the front panel conceals all controls to prevent tampering.
A Optional output wallplates for XLR or RCA connectivity – Extron WPD 102 XLRM and WPD 102 RCA wallplates can be connected to the line outputs of the AXI 22 AT D, to provide a two-gang wall installation with XLR audio inputs and XLR or RCA outputs.
A Power over Ethernet - PoE – Allows the AXI 22 AT D to receive power over the Ethernet cable.
A Mounts in an included single-gang decorator-style
wallplate – The single-gang decorator-style wallplate is available in black or white to blend with a wide range of environments.