AutoCAD

List of experiments to be performed:

1. Introduction to AutoCAD (Introduction to the basic commands used in AutoCAD)

2. Creation of simple objects using simple commands

3. To create special curves like parabola, spiral etc usingCubicspline, bspline.

4. To make Orthographic view of solids(Making 2D sketches of various figures using common commands)

5. To make Orthographic view of solids

6.To make orthographic view of the given figure

7. To make orthographic view of the given sketch

8. To make the orthographic projection of the given figure

9. To make an isometric view of dimensioned drawing using isometric grid and snap

10. To make an isometric view of dimensioned drawing

11. To make an isometric view of the given sketch

12. To make an isometric view of the given sketch.

13. To draw the isometric view of the given sketch.

14. To make the isometric view of the given sketch

15. To make the isometric dimensioned drawing of the given switch base

16.To draw the ISOMETRIC VIEW OF THE BRACKET GIVEN BELOW.

17. To draw the nut and bolts of square thread with external threading

18. To draw the nut and bolt of acme thread with internal threading

19. To draw the nut and bolt of acme thread with external threading

20. Drawing the 3D model of a simple object by extruding from its 2D model

21. To make a figure of spur gear

22. To extrude a 3D figure of SPUR gear

23. To extrude a 3D figure of straight bevel gear.

24. To make a 3D MODEL OF THE GIVEN FIGURES

25. To make a 3D model of nut and bolt

26. To extrude a 3D model of the rim of the car

27. To extrude a 3D model of cotter joint

28. To extrude a 3D model of helical spring

29. To extrude a 3D model of spur gear

30. To extrude the 3D model of nut and bolts with square thread

31. To extrude the 3D model of nut and bolts with square thread

32. The use of object snap and other precision tools to make our drawing more precise.

33. To organize the drawing with different layers and states and also changing the objects layer

34. To insert blocks from tool palettes from the design centre of AutoCAD

35. Working with hatching, dimensioning and accurate positioning in AutoCAD