Upload
sai-global-apac
View
214
Download
0
Embed Size (px)
Citation preview
7/31/2019 As 2405-2005 Laboratory Glassware - Kjeldahl Flasks
1/7
AS 24052005
Australian Standard
Laboratory glasswareKjeldahl flasks
AS24052005
7/31/2019 As 2405-2005 Laboratory Glassware - Kjeldahl Flasks
2/7
This Australian Standard was prepared by Committee CH-001, LaboratoryGlassware and Related Apparatus. It was approved on behalf of the Council ofStandards Australia on 14 October 2005.This Standard was published on 28 October 2005.
The following are represented on Committee CH-001:
Australian Chamber of Commerce and Industry
National Association of Testing Authorit ies Australia
National Measurement Ins titute
Royal Australian Chemical Institute
Royal College of Pathologists of Australasia
Science Industry AustraliaUniversity of New South Wales
University of Sydney
Keeping Standards up-to-date
Standards are living documents which reflect progress in science, technology andsystems. To maintain their currency, all Standards are periodically reviewed, andnew editions are published. Between editions, amendments may be issued.Standards may also be withdrawn. It is important that readers assure themselvesthey are using a current Standard, which should include any amendments whichmay have been published since the Standard was purchased.
Detailed information about Standards can be found by visiting the Standards WebShop at www.standards.com.au and looking up the relevant Standard in the on-linecatalogue.
Alternatively, the printed Catalogue provides information current at 1 January eachyear, and the monthly magazine, The Global Standard, has a full listing of revisionsand amendments published each month.
Australian StandardsTM
and other products and services developed by StandardsAustralia are published and distributed under contract by SAI Global, whichoperates the Standards Web Shop.
We also welcome suggestions for improvement in our Standards, and especiallyencourage readers to notify us immediately of any apparent inaccuracies orambiguities. Contact us via email at [email protected], or write to the ChiefExecutive, Standards Australia, GPO Box 476, Sydney, NSW 2001.
This Standard was issued in draft form for comment as DR 05085.
7/31/2019 As 2405-2005 Laboratory Glassware - Kjeldahl Flasks
3/7
AS 24052005
Australian Standard
Laboratory glasswareKjeldahl flasks
Originated as AS 24051981.Second edition 2005.
COPYRIGHT
Standards Australia
All rights are reserved. No part of this work may be reproduced or copied in any form or by
any means, electronic or mechanical, including photocopying, without the written
permission of the publisher.
Published by Standards Australia, GPO Box 476, Sydney, NSW 2001, Australia
ISBN 0 7337 6963 2
7/31/2019 As 2405-2005 Laboratory Glassware - Kjeldahl Flasks
4/7
AS 24052005 2
PREFACE
This Standard was prepared by the Standards Australia Committee CH-001, Laboratory
Glassware and Related Apparatus to supersede AS 24051981, Laboratory glassware
Kjeldahl flasks.
The objective of this Standard is to ensure that the requirements for Kjeldahl flasks
generally used for digestion and distillation procedures in the determination of nitrogen are
achieved.
The objective of this revision is to reconfirm the Standard with minor changes including the
following:
(a) Referenced documents have been updated.
(b) The Standard has been brought into line with current editorial practices.
The term informative has been used in this Standard to define the application of the
appendix to which it applies. An informative appendix is only for information andguidance.
7/31/2019 As 2405-2005 Laboratory Glassware - Kjeldahl Flasks
5/7
3 AS 24052005
CONTENTS
Page
1 SCOPE........................................................................................................................ 4
2 REFERENCED DOCUMENTS.................................................................................. 4
3 DEFINITION.............................................................................................................. 4
4 CAPACITIES OF FLASKS........................................................................................ 4
5 MATERIAL................................................................................................................ 4
6 CONSTRUCTION...................................................................................................... 4
7 DIMENSIONS AND TOLERANCES. ....................................................................... 5
8 FLASKS WITH INTERCHANGEABLE CONICAL GLASS JOINTS ...................... 5
9 MARKING ................................................................................................................. 5
APPENDIX A CARE IN THE USE OF KJELDAHL FLASKS.............................................. 7
7/31/2019 As 2405-2005 Laboratory Glassware - Kjeldahl Flasks
6/7
AS 24052005 4
Standards Australia www.standards.com.au
STANDARDS AUSTRALIA
Australian Standard
Laboratory glasswareKjeldahl flasks
1 SCOPE
This Standard specifies requirements for Kjeldahl flasks generally used for digestion and
distillation procedures in the determination of nitrogen.
2 REFERENCED DOCUMENTS
The following documents are referred to in this Standard:
AS
2409 Interchangeable conical ground glass joints
ISO
3585 Borosilicate glass 3.3Properties
3 DEFINITION
For the purpose of this Standard, the definition below applies.
3.1 Nominal capacity
The value which is closest to, but not greater than, the actual capacity of the flask to the
base of the neck.
4 CAPACITIES OF FLASKS
The nominal capacities of Kjeldahl flasks, in millilitres, shall be:
50, 100, 250, 500, 750, 1000.
5 MATERIAL
5.1 General
Flasks shall be made of borosilicate glass 3.3 (ISO 3585). They shall be as free as possible
from visible defects and internal stress.
NOTE: Directions for the care and use of Kjeldahl flasks are contained in Appendix A.
6 CONSTRUCTION
6.1 General
Flasks shall conform to the appropriate general shape shown in Figure 1.
6.2 Bulb
The shape of the bulb shall be approximately as shown in Figure 1. The lower half shall be
approximately hemispherical and the upper half shall have a gradual taper towards the neck.
6.3 Neck
The neck of the flask shall be substantially circular in cross-section. The top of the neckshall not be belled to any appreciable distance from the top of the flask and shall be
finished with a strengthening rim.
7/31/2019 As 2405-2005 Laboratory Glassware - Kjeldahl Flasks
7/7
This is a free preview. Purchase the entire publication at the link below:
Looking for additional Standards? Visit SAI Global Infostore
Subscribe to ourFree Newsletters about Australian Standards in Legislation; ISO, IEC, BSI and more
Do you need to Manage Standards Collections Online?
Learn about LexConnect, All Jurisdictions, Standards referenced in Australian legislation
Do you want to know when a Standard has changed?
Want to become an SAI Global Standards Sales Affiliate?
Learn about other SAI Global Services:
LOGICOM Military Parts and Supplier DatabaseMetals Infobase Database of Metal Grades, Standards and Manufacturers
Materials Infobase Database of Materials, Standards and Suppliers
Database of European Law, CELEX and Court Decisions
Need to speak with a Customer Service Representative - Contact Us
AS 2405-2005, Laboratory glassware - Kjeldahlflasks
http://infostore.saiglobal.com/store?utm_source=PDF&utm_medium=Website_Infostore&utm_campaign=DocSharingSiteshttp://www.saiglobal.com/Information/Standards/Newsletters/?utm_source=PDF&utm_medium=Website_Infostore&utm_campaign=DocSharingSiteshttp://www.saiglobal.com/Information/Standards/Collections/?utm_source=PDF&utm_medium=Website_Infostore&utm_campaign=DocSharingSiteshttp://www.saiglobal.com/Information/Standards/Law/?utm_source=PDF&utm_medium=Website_Infostore&utm_campaign=DocSharingSiteshttp://www.saiglobal.com/Information/Standards/StandardsWatch/?utm_source=PDF&utm_medium=Website_Infostore&utm_campaign=DocSharingSiteshttp://www.saiglobal.com/Information/Standards/Affiliate/?utm_source=PDF&utm_medium=Website_Infostore&utm_campaign=DocSharingSiteshttp://www.saiglobal.com/Information/Standards/Databases/LOGICOM/?utm_source=PDF&utm_medium=Website_Infostore&utm_campaign=DocSharingSiteshttp://www.saiglobal.com/Information/Standards/Databases/LOGICOM/?utm_source=PDF&utm_medium=Website_Infostore&utm_campaign=DocSharingSiteshttp://www.saiglobal.com/Information/Standards/Databases/Metals/?utm_source=PDF&utm_medium=Website_Infostore&utm_campaign=DocSharingSiteshttp://www.saiglobal.com/Information/Standards/Databases/Materials/?utm_source=PDF&utm_medium=Website_Infostore&utm_campaign=DocSharingSiteshttp://www.saiglobal.com/Information/Standards/Databases/European-Law/?utm_source=PDF&utm_medium=Website_Infostore&utm_campaign=DocSharingSiteshttp://infostore.saiglobal.com/store/getpage.aspx?path=/InformationServices/shop/pages/ContactingUs.htm&utm_source=PDF&utm_medium=Website_Infostore&utm_campaign=DocSharingSiteshttp://infostore.saiglobal.com/store/Details.aspx?ProductId=270160&utm_source=PDF&utm_medium=Website_Infostore&utm_campaign=DocSharingSiteshttp://infostore.saiglobal.com/store/getpage.aspx?path=/InformationServices/shop/pages/ContactingUs.htm&utm_source=PDF&utm_medium=Website_Infostore&utm_campaign=DocSharingSiteshttp://www.saiglobal.com/Information/Standards/Databases/European-Law/?utm_source=PDF&utm_medium=Website_Infostore&utm_campaign=DocSharingSiteshttp://www.saiglobal.com/Information/Standards/Databases/Materials/?utm_source=PDF&utm_medium=Website_Infostore&utm_campaign=DocSharingSiteshttp://www.saiglobal.com/Information/Standards/Databases/Metals/?utm_source=PDF&utm_medium=Website_Infostore&utm_campaign=DocSharingSiteshttp://www.saiglobal.com/Information/Standards/Databases/LOGICOM/?utm_source=PDF&utm_medium=Website_Infostore&utm_campaign=DocSharingSiteshttp://www.saiglobal.com/Information/Standards/Affiliate/?utm_source=PDF&utm_medium=Website_Infostore&utm_campaign=DocSharingSiteshttp://www.saiglobal.com/Information/Standards/StandardsWatch/?utm_source=PDF&utm_medium=Website_Infostore&utm_campaign=DocSharingSiteshttp://www.saiglobal.com/Information/Standards/Law/?utm_source=PDF&utm_medium=Website_Infostore&utm_campaign=DocSharingSiteshttp://www.saiglobal.com/Information/Standards/Collections/?utm_source=PDF&utm_medium=Website_Infostore&utm_campaign=DocSharingSiteshttp://www.saiglobal.com/Information/Standards/Newsletters/?utm_source=PDF&utm_medium=Website_Infostore&utm_campaign=DocSharingSiteshttp://infostore.saiglobal.com/store?utm_source=PDF&utm_medium=Website_Infostore&utm_campaign=DocSharingSites