• No landline needed – uses GSM cellular network • Great solution for VoIP users • Monitors all controllers with an alarm output, from simple thermostats to fully integrated systems • Receive a daily status message from the Wireless Alarm Manager • Monitor power outages – alarm continues to send messages for 10-hours after a power failure • Sends a text message to 1 to 4 cell phones • Check your greenhouse status anytime, anywhere • Easily programmed by text message or email • Monitors up to 4 individual alarm circuits • Selectable delayed response time • Continues to send reminder alarm texts until alarm is reset • Password protected • Programmable ID specifies which controller is in alarm • Back-up rechargeable battery warns when voltage is low • Easy to wire SPECIFICATIONS • Requires text messaging through a Global System for Mobile communication (GSM) service carrier • 120 volt power source (which alarm will monitor for power outages) • Requires user purchased SIM card (Subscriber Identity Module) • Dimensions: 5.625” x 3.250” x 1.375” • Part # M-5810 Alarm Managers Alarm Manager Cellular Alarm Manager Ethernet Alarm Manager The Alarm Managers communicate directly with your environmental control so when the greenhouse temperature is in alarm condition, or in the event of a power failure, they contact up to four phone numbers and send an alert. These remarkable devices persevere until the alarm is acknowledged. • Assign a “normal state” for each input • Create a call list with up to eight phone numbers • Determine a time delay for each input • Record a custom message that indicates the location of the alarm (e.g. North house cold) • Monitors eight dry contact inputs • Power alarm calls you if the system’s power is cut off • Rechargeable back-up battery if power outages occur • Plug-in wall transformer, splitter and phone extension cable included • FCC approved and registered • Meshes with control complexity levels – from a simple thermostat (hot/cold) system to a fully integrated control • Easy plug and play installation with EnviroSTEP, VersiSTEP, STEP Up and Versatile Vent controls SPECIFICATIONS • Requires 0.1 amp @ 115 VAC • Dimensions: 8.79” x 4.62” x 2.25” • Part # M-5800 To find out more call 800.821.5829, email [email protected] or visit www.wadsworthcontrols.com • Expands capabilities of our Alarm Manager to include Ethernet • Redundancy of landline and Ethernet keeps your crop doubly safe • Must download and connect Data Capture app for Ethernet to function • Integrated auto-dialer, Ethernet port • Monitors up to eight (8) inputs/zones • LCD displays real time data • Displays minimum and maximum temperatures • Network ready – onboard memory • Programmable alarm delay • Record identification message for each input/zone • Uses standard analog phone line • Monitors power • 24-hour rechargeable backup battery • Sends emails • No monitoring fees SPECIFICATIONS • Splitter, telephone extension and Ethernet cable included • FCC Approved and Registered. • Requires analog phone line. • Operating temperature range 32°F to 125°F • Dimensions: 5.0" x 7.5" x 1.75" (W x L x H)

Alarm Managers - Wadsworth Control Systems Inc · Alarm Managers Alarm Manager Cellular Alarm Manager Ethernet Alarm Manager The Alarm Managers communicate directly with your environmental

Download PDF Report

Upload
others
View
59
Download
2

Embed Size (px)

Citation preview

Page 1: Alarm Managers - Wadsworth Control Systems Inc · Alarm Managers Alarm Manager Cellular Alarm Manager Ethernet Alarm Manager The Alarm Managers communicate directly with your environmental

• No landline needed – uses GSM cellular network• Great solution for VoIP users• Monitors all controllers with an alarm output, from

simple thermostats to fully integrated systems• Receive a daily status message from the Wireless

Alarm Manager• Monitor power outages – alarm continues to send

messages for 10-hours after a power failure• Sends a text message to 1 to 4 cell phones• Check your greenhouse status anytime, anywhere• Easily programmed by text message or email• Monitors up to 4 individual alarm circuits• Selectable delayed response time• Continues to send reminder alarm texts until alarm

is reset• Password protected• Programmable ID specifies which controller is in alarm• Back-up rechargeable battery warns when voltage

is low• Easy to wire

SPECIFICATIONS• Requires text messaging through a Global System

for Mobile communication (GSM) service carrier• 120 volt power source (which alarm will monitor

for power outages)• Requires user purchased SIM card

(Subscriber Identity Module) • Dimensions: 5.625”x 3.250”x 1.375”• Part # M-5810

Alarm Managers

Alarm Manager Cellular Alarm Manager Ethernet Alarm Manager

The Alarm Managers communicate directly with your environmental control so when the greenhouse temperature is in alarm condition, or in the event of a power failure, they contactup to four phone numbers and send an alert. These remarkable devices persevere until thealarm is acknowledged.

• Assign a “normal state” for each input• Create a call list with up to eight phone numbers• Determine a time delay for each input• Record a custom message that indicates the location

of the alarm (e.g. North house cold)• Monitors eight dry contact inputs• Power alarm calls you if the system’s power is cut off• Rechargeable back-up battery if power outages occur• Plug-in wall transformer, splitter and phone extension

cable included• FCC approved and registered• Meshes with control complexity levels – from a simple

thermostat (hot/cold) system to a fully integrated control

• Easy plug and play installation with EnviroSTEP, VersiSTEP, STEP Up and Versatile Vent controls

SPECIFICATIONS• Requires 0.1 amp @ 115 VAC• Dimensions: 8.79” x 4.62” x 2.25”• Part # M-5800

To find out more call 800.821.5829, email [email protected] or visit www.wadsworthcontrols.com

• Expands capabilities of our Alarm Manager to include Ethernet

• Redundancy of landline and Ethernet keeps your crop doubly safe

• Must download and connect Data Capture app for Ethernet to function

• Integrated auto-dialer, Ethernet port• Monitors up to eight (8) inputs/zones• LCD displays real time data• Displays minimum and maximum temperatures• Network ready – onboard memory• Programmable alarm delay• Record identification message for each

input/zone• Uses standard analog phone line• Monitors power• 24-hour rechargeable backup battery• Sends emails• No monitoring fees

SPECIFICATIONS• Splitter, telephone extension and Ethernet

cable included• FCC Approved and Registered. • Requires analog phone line.• Operating temperature range 32°F to 125°F• Dimensions: 5.0" x 7.5" x 1.75" (W x L x H)