Adventure Kings WiFi Refrigerator USER MANUAL manuals/WiFi Fridge manual... · ge aa page 2 INSTRUCTIONS FOR USE TURNING ON THE REFRIGERATOR 1. Plug the fridge into a power point

Please read and understand these instructions and the safety information section before using your refrigerator.

Adventure Kings WiFi Refrigerator

USER MANUAL

Adventure Kings WiFi Fridge Manual

CONTENTS

Safety Information 1

Notes on using the product 1

Instructions for use 2

Cleaning and maintaining your refrigerator 3

Using the Evakool application to view and change the fridge’s temperature with your smart device. 4

Troubleshooting the Evakool application 12

General Troubleshooting 13

Error Codes 14

Adventure Kings WiFi Fridge Manual page 1

SAFETY INFORMATION

• Do not touch any exposed cables or wires.• Do not operate the fridge in wet or damp environments. • Do not submerge the fridge in water.• When using the fridge in a vehicle, make sure that the circuit being

used is fused.• Any installation of DC power systems should be handled by a

qualified professional.• Make sure the source voltage is correct. The technical data label

has the voltage data for the fridge.• Ensure that the fridge is kept steady and secure as it can become

heavy when filled.• A filled fridge may be heavy so be cautious when attempting to lift

it.

NOTES ON USING THE PRODUCT

• Good ventilation is necessary for the fridge. Allow a gap of at least 20cm around the vents to allow for airflow.

• If its power supply is cut off, the fridge will switch off automatically and turn back on when it starts to receive power.

• Do not place any electrical devices inside the refrigerator as moisture could harm them.

• Frost build-up can affect the cooling ability of the fridge. Humidity in the unit can cause this frost.

• Placing your refrigerator near a heat source can reduce its efficiency and heat up its contents. Make sure that you keep the fridge several metres away from heat sources.

• Place the refrigerator on a flat surface and away from any edges. When using the fridge in a vehicle, please use a fastening device to secure it.


INSTRUCTIONS FOR USE

TURNING ON THE REFRIGERATOR

1. Plug the fridge into a power point. An orange LED labelled “RUN” will be illuminated to indicate that the unit is receiving power.

2. Hold the power button for five seconds to turn on the refrigerator. The power LED will be illuminated with a green light when the fridge is running and the screen will show the temperature.

ADJUSTING THE REFRIGERATOR’S TEMPERATURE

1. Press the settings button ONCE to initiate the temperature selection menu. For the dual zone models, select the left compartment by pressing the settings once and the right compartment by presing it twice.

2. Use the and buttons to raise or lower the temperature respectively.

3. Press the settings button twice— or do not press any button for five seconds — to confirm the selection.

4. At first the LED display will show the current temperature but will start to decrease to the target temperature after approximately 5 minutes. The LED light will glow green while the temperature is changing and will glow orange when set.

Settings Controls Power

Display panel

Display for left compartment

Display for right compartment


SWAPPING BETWEEN UNITS OF TEMPERATURE

1. Press the settings button TWICE to initiate the unit selection menu.2. Use the and buttons to select your desired unit.3. Press the settings button twice— or do not press any button for five

seconds — to confirm the selection.

CHANGING THE BATTERY VOLTAGE SETTING

1. Hold down the battery button for THREE seconds to initiate the voltage control menu.

2. Use the and buttons to select your desired voltage. We suggest your keep the voltage set to LOW but the exact voltage details are as follows:

3. Press the settings button twice— or do not press any button for five seconds — to confirm the selection.

CLEANING AND MAINTAINING YOUR REFRIGERATOR • Keep the fridge clean by wiping it down with a damp cloth, inside

and out, each week.• If the fridge is dirty DO NOT use soaps, abrasive products or

detergents, as these may damage the refrigerator. Instead, use a small amount of sodium bicarbonate fully dissolved in lukewarm water. Rinse thoroughly with clean water and dry carefully.

• Never clean the appliance under running water or using a hose.• Do not leave food in the refrigerator when it is unpowered as the

food could spoil.

12V 24V

LOW – 11.0 volts LOW – 23.0 volts

MED – 12.0 volts MED – 24.0 volts

HIGH – 12.5 volts HIGH – 24.5 volts


USING THE EVAKOOL APP TO VIEW AND CHANGE THE FRIDGE’S TEMPERATURE WITH YOUR SMART DEVICE.The Evakool app for iOS and Android can be used to view or change the temperature and voltage of your WiFi-equipped Adventure Kings refrigerators.

HOW TO VIEW THE FRIDGE’S TEMPERATURE AND VOLTAGE FROM YOUR DEVICE:

1. Download the Evakool app from the iTunes or Google Play store.

2. Change your phone’s wireless network settings to connect to the fridge’s network. Please note that you cannot connect your phone to other wireless networks while doing this.


3. Open the Evakool app. Select your fridge from the menu or press add and select it there.

If you cannot find your fridge here, make sure that you are properly connected to the fridge’s network and that your device’s wireless setting has been enabled.


4. Register an account, making sure that you select average user for the account type.

The user ID needs to be 11 numbers long; you cannot use letters or other characters. The password should be 6 numbers long.

5. Log into the application using your details.


6. You can now use the application to monitor your fridge’s voltage or temperature.

7. You can also turn your refrigerator on or off. To do so, press the settings button or swipe in from the right side of the screen.

8. Now select on/off to be taken to a menu to turn your fridge on or off from your phone.


HOW TO ACCESS THE TEMPERATURE AND VOLTAGE CONTROL FEATURES OF THE EVAKOOL APP1. Open the Evakool app, select your fridge and login using

the steps starting on page 5.

2. Press settings and then select account upgrade from the settings menu.

You will be taken to a page where you can enter some details to upgrade your account. To get these details you must first register your warranty on the Evakool website (https://www.evakool.com/productregistration/productregistration/registerProduct/). Following this you must email [email protected] with your warranty information and request an upgrade code.


3. On this page, enter the details that Evakool sent to you after registering your warrant with them.

You will now have access to the temperature and voltage control functionalities of the application. Continue onto the next page to see how to alter the temperature and voltage of your fridge, and how to utilise the graphing functions of the application.


4. To control the temperature, press the settings button and then select settings from this menu. Here you are able to control the temperature, voltage and the temperature unit used.

5. To access graphing, from the main screen of the application press settings then then graphing.


You must select zone or voltage to change the the temperature or voltage graphs respectively. Use these graphs to troubleshoot problems that you might have or to check the performance of your fridge. Data are stored for up to 24 hours and are recorded after the fridge has been running for 10 minutes.


TROUBLESHOOTING THE EVAKOOL APP

PROBLEM SOLUTION

I cannot see or connect to the wireless network

• Check that your device has its Wi-Fi capabilities turned on.

• Make sure you are in range of the fridge (normally around 10-20 meters).

• Make sure you are using the correct passcode “55555555” (8 x 5’s) for the Wi-Fi Network.

• You may already be connected to a different wireless network.

• Turn the fridge and your phone off and on again.

I cannot pair the fridge with the application

• Ensure that you are connected to the fridge’s wireless network.

• Check that the Fridge ID is the same as the wireless network the fridge is projecting.

• Make sure you are using the correct user ID and Password.

If the above has failed, follow the below steps:

• Uninstall the Evakool app. Close all applications in the background.

• Turn off the fridge and phone.

• Turn both the fridge and the phone back on after a couple of minutes.

• Re-install the Evakool app.

If you are still having problems, please do not hesitate to contact Evakool (07) 5492 7777.


GENERAL TROUBLESHOOTING

PROBLEM SOLUTION

The appliance is not turning on.

• Check the power supply.

• Ensure the power plug is placed firmly in its socket.

• Check whether the fuse needs replacing.

• Make sure that the fridge has been turned on and is not in standby mode. See page 2 for instructions.

The food inside is frozen or very icy.

• The fridge’s temperature is too low. See the instructions on page 2 for how to increase the temperature.

Bad performance in refrigeration

• The set temperature might be inappropriate. Try changing it as per page 2.

• The lid could be unlocked, open or is not able to fully close. Remove the blockage and close the fridge completely.

• The refrigerator’s seal may be broken or failing. Check to see if you see any faults and contact Evakool if you need a replacement.

• The fridge may have poor ventilation. Try removing any objects that are blocking the ventilation vents.

• The fridge may be overfull. Try removing some items.

• The contents of the fridge may have been overly warm when placed inside. Let food cool down before refrigerating them.

• There is a heat source near the unit. Move the fridge away from sources of heat.

The sound of moving liquid can be heard within the refrigerator

• This is normal behaviour and is due to the flow of the refrigerant. No fix should be necessary.

Unusual noise can be heard when the refrigerator is working

• The refrigerator is not placed on a level surface. Carefully move the fridge to a level surface. Be careful not to move heavy objects.

• Something may have come loose in the refrigerator. Contact Evakool for advice about this.


ERROR CODESThe Adventure Kings WiFi Fridge has an error system where a code is displayed as a series of flashes over a four second period. Each sequence of flashes indicates a specific error as shown in the table below.

Note: this fridge is fitted with an automatic 60 second restart delay. This will be activated if your fridge enters an error mode. It is designed to protect the fridge if an error occurs.

CODE WARNING SOLUTION

1 flashevery four seconds

Low voltage

• Please check the source voltage to ensure it is above the cut out range. Try lowering the voltage cut out setting to LOW (page 2).

• The vehicle cabling may be inadequate or unsuitable. Please refer to the cable specifications table on the next page for correct cable thickness.

• Try on another power source.

2 flashesevery four seconds

Fan issue • Fan is drawing too many amps (over 1 amp) – replace fan. Contact Evakool about this.


Compressor start issue

• Unplug the refrigerator for 10 minutes and then restart it.

• Possible electronic box or compressor fault. Contact Evakool about this.

• Try on another power source.


Compressor speed is too low

• Unplug the refrigerator for 10 minutes and then restart it.

• Reduce number of items inside of fridge.

• Lower the ambient temperature near the fridge by moving it away from heat sources or into a cooler location.

• Clean vents and ensure clear air flow over compressor


Ambient temperature is

too high

• Clean vents and ensure clear air flow

• Fan fault – Contact Evakool to replace the fan.


NOTES ON OPERATION

• Power: The electronic control module controls the compressor motor and has the function of a three-stage battery protection. When the input voltage drops below the minimum, the compressor will cut out; when the voltage comes back up to the cut-in value, the compressor will restart automatically.

• Battery Protection: The Danfoss compressor requires approximately 11 volts (for a 12V system) or 23.0 volts (for a 24V system) to operate. If the voltage drops below this, the fridge will stop running.

Cable Specification Table

The DC cables must have a suitable cross-section for their length, according to this table:

Cable area 12V Max Cable Length*

24V Max Cable Length*

[mm2] AWG [m] [ft.] [m] [ft.]

2.5 13 2.5 8 5 16

4 11 4 13 8 26

6 9 6 20 12 39

10 7 10 33 20 66

* - Note, the length is from the battery to the refrigerator.


WARRANTY STATEMENTTERMS AND CONDITIONS

• The warranty period commences from the date of purchase by the original purchaser from an authorised EvaKool dealer.

• EvaKool will honour this warranty on presentation of proof of purchase of the unit to EvaKool or its approved service agent. The service agent may be requested to provide EvaKool with a photocopy of the proof of purchase to obtain approval to proceed prior to warranty being honored.

• Evakool will not be held responsible for any costs incurred in making a warranty claim.

• Please telephone (07) 5492 7777 for the name of an authorized service agent or refer to list provided. It is the purchaser’s responsibility to freight the unit to and from the service agent.

• EvaKool will not be held responsible for any damage or loss suffered or cost incurred whilst fridge is in transit.

• Warranty repairs may only be carried out by an authorised service agent. EvaKool will not reimburse repair claims carried out by unauthorized service agents. Any unauthorized tampering with any part of the unit will automatically void the warranty.

• Service agents may charge a fee for viewing or testing the unit. This is not covered by EvaKool or this warranty and is payable at the service point unless authorized by EvaKool.

• Any Evakool authorized service centre in Australia will be able to carry out the service of your unit. If a repair needs to be undertaken and is covered in terms of this warranty a warranty authorization number must be obtained prior to commencement of any work.

EVAKOOL WILL NOT ACCEPT A WARRANTY CLAIM IF:

1. Modifications have been carried out to the unit without EvaKool’s written authority.

2. Damage to or failure of the unit has been caused in EvaKool’s opinion by incorrect, extreme or unreasonable use.

3. Damage to or failure of the unit has been caused in EvaKool’s opinion by misuse, neglect, accident, impact or similar cause. Refer the preventative maintenance guidelines.

• EvaKool has total discretion on the variation of the warranty terms.

• Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for major failure and for compensation for any other reasonably foreseeable loss or damage. You are

• also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.

• The above warranty conditions are in addition to any other rights and/or remedies as per the applicable law.

• Failure to follow the guidelines/recommendations in this manual may void the warranty.

• This warranty cannot be varied by others.

Nexberg Pty. Ltd. trading as EvaKool undertakes to the original purchaser that this product is sold free of defect in materials and/or workmanship under normal use for a period of 24 months. Subject to the following:

COMPLETE THE ENCLOSED WARRANTY CARD AND RETURN WITHIN THIRTY (30) DAYS OF PURCHASE

POST or Register your product warranty

ONLINE at www.evakool.com


Documents

Adventure Kings WiFi Refrigerator USER MANUAL manuals/WiFi Fridge manual... · ge aa page 2 INSTRUCTIONS FOR USE TURNING ON THE REFRIGERATOR 1. Plug the fridge into a power point