Upload
others
View
0
Download
0
Embed Size (px)
Citation preview
Beka, Inc. • 542 Selby Ave • St. Paul, MN 55102 • USA 1-888-999-2352 • www.Bekainc.com
ADJUSTABLE TAPESTRY LOOM - The Grizzly -
Parts: - 4 Side Uprights (38” long pcs) - 2 Beams (pieces with plastic teeth) - 2 Feet - 6 Positioning Blocks (5” long pcs) - 2 Assembly Hardware Packs: • 8 - 1-1/2” wood screws • 16 sets of bolts, washers & wing nuts - 2 Pickup Sticks - 2 Shuttles
Assembly Instructions:
Step 1
Step 2
Step 1) Use wood screws to attach a Positioning Block to the end of each Beam. Step 2) Use bolts to connect uprights in pairs; connect uprights so the two sets are the same length. Secure with washers and wing nuts. Step 3) Lay uprights on a table or floor and attach beams; use bolts to connect positioning blocks to uprights. Orient beams so teeth are close to the center of the loom; teeth are on the lower edge of the top beam and the top edge of the bottom beam.
Step 3
Step 4) Attach each beam at the level you choose for the project size you want. Depending on the position of the lower beam: - extra positioning blocks (included) may be needed as spacers - extra bolts (included) may be used to connect uprights securely Step 5) Attach feet to bottom of each set of uprights; secure with washers and wing nuts.. ENJOY!!!
Use the loom standing upright on the floor or on a table top. -To remove a finished project, remove the bolts holding one of the beams in place. Slide your finished weaving off the beam teeth. -For general “How-to-Weave” information go to our Weaving Frame Instructions online: http://www.bekainc.com/images/stories/wf14.pdf
Step 4
Step 5
Beka, Inc. • 542 Selby Ave • St. Paul, MN 55102 • USA 1-888-999-2352 • www.Bekainc.com
With one upright for table top use
With two uprights Standing on the floor