1. Remove the footrest hinge cover by removing the screw. 3. To remove the main carriage cover, remove the 2 screws that are located along the front bottom edge. 6. Cut the cable tie that holds the batteries together. 8. Slide the batteries out from the carriage chassis and replace with the new ones. 7. Remove the two screws from the metal straps. 9. Attach a new tie clip around the batteries. Screw the metal straps together. Attach the link wire frst, Positive and then the Negative terminals back on to the batteries. IMPORTANT DO NOT ALLOW THE METAL STRAP MAKE CONTACT WITH THE BATTERY TERMINALS. 5. Remove the Negative frst and then the Positive terminal connectors from the batteries. Remove the joini ng lin k wir e connect or be twee n the two batteries. 2. Undo screws on the bezel around the seat post and remove. Cut and undo the cable tie around the gaitor. Remove the gaitor. 4. Tilt the footplate and gradually remove the cover on an angle. It may be necessary to loosen the footplate adjusting bolt. Replacing Batteries June 2011 The following procedure must be STRICTL Y adhered to, to avoid damage. DAMAGE CAUSED BY THE INDIVIDUAL IS AT THEIR OWN RISK. TSBR3537/140611 10. Place the carriage cover back onto the chassis and attach with the two screws. If neccessary tighten the footplate adjusting bolt. Attach the footrest hinge cover. Screw the bezel around the seat post and attach the gaitor using a new cable tie.

Acorn Stairlifts - 3537 Tech Support Replacing Batteries

Download PDF Report

Upload
jonathan-bryant
View
12
Download
0

Embed Size (px)

DESCRIPTION

Technical instruction on how to replace batteries on an Acorn stairlift.The procedure must be STRICTLY adhered to, to avoid damage.DAMAGE CAUSED BY THE INDIVIDUAL IS AT THEIR OWN RISK.

Citation preview

1. Remove the footrest hinge cover by removing the screw.

3. To remove the maincarriage cover, remove the2 screws that are locatedalong the front bottom edge.

6. Cut the cable tie that holds the batteries together.

8. Slide the batteries out from the carriage chassis and replace with the new ones.

7. Remove the two screws from the metal straps.

9. Attach a new tie clip around the batteries.

Screw the metal straps together.

Attach the link wire first, Positive and then theNegative terminals back on to the batteries.

IMPORTANTDO NOT ALLOW THE METAL STRAP MAKE CONTACT WITH THE BATTERY TERMINALS.

5. Remove the Negative first andthen the Positive terminal connectors from the batteries. Remove thejoining link wire connector betweenthe two batteries.

2. Undo screws on the bezel around the seat post and remove. Cut and undo the cable tie around the gaitor. Remove the gaitor.

4. Tilt the footplate and graduallyremove the cover on an angle. It may be necessary to loosen thefootplate adjusting bolt.

Replacing BatteriesJune 2011

The following procedure must be STRICTLY adhered to, to avoid damage. DAMAGE CAUSED BY THE INDIVIDUAL IS AT THEIR OWN RISK.

TSBR3537/140611

10. Place the carriage cover back onto the chassis and attach with the two screws.If neccessary tighten the footplate adjusting bolt. Attach the footrest hinge cover.

Screw the bezel around the seat post and attach the gaitor using a new cable tie.