ABLAZE APPLICATIONS: ABLAZE is a non-selective herbicide made from minimum risk ingredients that are safer for the envi-ronment and for workers. When you spray ABLAZE on weeds and grasses, it binds to the surface of the leaf and begins to destroy the cell structure through a burn down process. After ABLAZE is applied, the plant begins to stress, and results can be seen in as little as 24-48 hours.

Non-selective WEED AND GRASS herbicide

WEED AND GRASS KILLER• ABLAZE is for use on weeds and grasses. Use in spot applications in most areas. • Wilting begins within hours. Weeds and grasses are chlorotic in about 48 hours.• ABLAZE knocks down early stage annual weeds quickly. Perennial weeds may

need multiple sprays to kill roots.• Spray ABLAZE between planting rows and under fruit trees, berries, grapes, and

ornamental crops.• New planting can begin within hours after treating an area with ABLAZE• ABLAZE does not translocate to the roots of non-target plants.• Workers can safely enter areas treated with ABLAZE right after spraying!

Where To Use ABLAZE:• Maintain planting rows and beds.

• Keep centers clear in orchards and vineyards.

• Edge around trees, ornamentals and nursery crops.

• Keep fence lines clear of weeds and grasses.

• Spot treat around greenhouses and outbuildings, along driveways and sidewalks.

ABLAZE is manufactured in compliance with USA EPA Minimum Risk Pesticide Regulation 40CFR 152.25 and as such is exempt from registration.

TM

Before spraying

48-hours after spraying

Before spraying

48-hours after spraying

CRABGRASS

BERMUDAGRASS

Application/Dilution/Dosage

Younger Smaller Weeds: Mix with water at 4:1 ratio (4 parts water to 1 part ABLAZE). Apply diluted mixture as a fine mist. Spray diluted product directly on to target vegetation to completely cover all of the plant’s leaves.Older Larger Weeds: Product may be diluted less for use against more vigorous weeds and may even be used full strength. Apply the mixture as a fine mist. Completely saturate the top and bottom of all target foliage. Expect to make repeat applications to control more established weeds.

WARNING: Do not allow spray to contact desirable foliage.All contacted vegetation will be affected.

For best results, spray in full sunlight during the warmest part of day. ABLAZE works best in non-shaded areas when temperatures are above 75°F (24°C). Spray ABLAZE directly on weeds until wet, but not to the point of run-off. Always spray ABLAZE when the plant is actively grow-ing. Fill tank 1/2 full with water. Start agitation, add ABLAZE and then fill tank with water. Some agitation during application is recommended. Repeat applications as needed.

ABLAZE TM

Soil Technologies Corp.2103 185th Street,Fairfield,

IA 52556, U.S.A.Tel.: +1-641-472-3963 ● FAX: +1-641-472-6189

www.soiltechcorp.com