Abis over IP configuration locally from the BTS side

1. Ensure the Network Connectivity to the BSC: To ensure the network connectivity to the BSC, you have to do the following:

a- connect the uplink of the BTS (Ethernet cable) to your PC

(Example:- EMS6 port 1=> PC Ethernet port).

b- Set the IP Address of the PC Like the BTS IP, the Default Gateway like the Default Gateway of the

BTS (forward route address in the BTS IP route), with a Subnet Mask that allows the IP Address and

the Default Gateway to be in the same subnet.

Example:

Gateway BTS IP BSC IP Sub net Mask Mask IP

10.164.25.41 10.164.25.44 10.164.24.12 255.255.255.248 10.164.24.8

PC IP Address should be configured as follows:

c- Ping the Default gateway & the BSC IP from the CMD of your PC, the result should be as

follows:

d- Now, we are sure that the network connectivity to the gateway is OK.

Note :- to check connection to BSC DC team mast config router and then ping on BSC IP address

2- Connect locally to the BTS through the Site Maintenance Terminal (SMT):

a- Connect the Site Maintenance Terminal (SMT) PC to the Ethernet port on the GTMU

(ETH) through an Ethernet cable.

b- Ensure that IP address and subnet mask of the SMT PC are set correctly. The IP

address is in the same network segment as the IP address (192.168.0.72/255.255.255.0)

of the BTS.

c- To verify the network connection between the computer and the BTS Run ping 192.168.0.72 from the CMD on the computer.

d- After ensuring the local connectivity to the BTS as above, open the Site Maintenance Terminal (SMT). And make configuration as following steps

Note: If the BTS OML has been established, run the LST BTSLOCALETHPORT command on the BSC LMT to check whether the ETH port is enabled. If not, run the

SET BTSLOCALETHPORT command to enable the port.

3- Access the SMT by the User Name:- admin and Password :-hwbs@com

4- After accessing the SMT, you have to get the management of the BTS. Double click

the Site Management Right and press the Get push button as below:

5- Double click the IP Over FE Static IP to start the BTS local configuration

a-Config BTS,BSC and VLAN

Click config tap

Static IP status => Enable

Com type => port IP

BTS IP address=>10.164.25.44

BSC IP Address =>10.164.24.12

Press OK

Click on static query tap and press OK to ensure data entry succeed

b- Config Port IP

Click on Config tap

Rack Number =>0

Sub Rack Number=>0

Slot Number =>6

Port Type=> Ethernet Port

Port Number =>0

FE0 IP Address =>10.164.25.44(BTS IP)

FE0 IP mask address =>255.255.255.248

Press OK

Click on static query tap and press OK to ensure data entry succeed

c- Config Route

Click on Config tap

Rack Number =>0

Sub Rack Number=>0

Slot Number =>6

Destination IP Address =>10.164.24.8

Destination Mask Address =>255.255.255.248

Route Type => Next

Next Hop IP Address =>10.164.25.41

Click on static query tap and press OK to ensure data entry succeed

6-To release the site management double clicks the Site Management Right and click

release.

7- Finally, you can take off the Ethernet cable from the ETH port of the GTMU, and waiting for about 5 minutes to check the Leds status of the port FE0 and ensure that the

BTS became UP and managed from the Web LMT (You can also check with NOC to ensure this Issue).

Note: All IP address and IP masks change due to Site and BSC IDs