A common wall between the zones

Zone 1 with four walls and four windows

Zone 2 with four walls and four windows

An example of a model with two zones

This is the ORIGINAL wall BLOCK

The common wall between the zones is constructed from an ordinary ’wall block’. Take an ordinary wall block from the library and look behind the block mask – see the

example below

The block should be replaced by one of this kind

NEW BLOCK – a common wall between two zones

INTERIOR WALL CLADDING 1 replaces EXTERIOR WALL CLADDING

Inputs Zone 1 and Radiation 1 replace Geometry

NEW BLOCK

INTERIOR WALL CLADDING 1 is a copy of INTERIOR WALL CLADDING 2, with one new output – Last node.

New Construction output

Last node.

CHANGES IN THE MAIN BLOCK MASK

CHANGES IN THE MAIN BLOCK MASK

Define material 1 in the block mask of INTERIOR WALL CLADDING 1

Go one level below and define surface transfer coefficients alfacin1 and betaPin1 in the block mask of Internal surface node /CTH. Check the names of the parameters with the ones specified in the main block mask (see slide 6)

Do the same for the block INTERIOR WALL CLADDING 2 / Internal surface node /CTH.

Check the names of the parameters with the ones specified in the main block mask (see slide 6)