96-1

Center console switches, removing and installing

CAUTION!

Disconnect the battery Ground (GND) strap before working on the electrical system.

Notes:

Before disconnecting the battery, determine the correct coding for the anti-theft radio.

After reconnecting the battery, check and activate the vehicle's electrical equipment (radio, clock, comfort and convenience features, etc.) as outlined in this Repair Manual or the Owner's Manual.

Page 1 of 3Center console switches, removing and installing

11/20/2002http://127.0.0.1:8080/audi/servlet/Display?action=Goto&type=repair&id=AUDI.B5.EE01.96.1

96-2

Switches, removing and installing

Removing

- Insert small screwdriver or flat plastic tool as shown, press against opposite side of switch and pry off switch plate.

- Tape off area above switches or front of radio with masking tape, if necessary.

Installing

- Pull switch out forward using standard or flat-nose pliers.

- Disconnect harness connector.

- Press switch plate onto switch so it engages audibly.

- Connect harness connector and press switch in by hand as far as possible.

Page 2 of 3Center console switches, removing and installing

11/20/2002http://127.0.0.1:8080/audi/servlet/Display?action=Goto&type=repair&id=AUDI.B5.EE01.96.1

96-3

Emergency flasher relay, location

The emergency flasher relay is integrated in the emergency flasher switch.

- Removing and installing Page 96-2 .

Page 3 of 3Center console switches, removing and installing

11/20/2002http://127.0.0.1:8080/audi/servlet/Display?action=Goto&type=repair&id=AUDI.B5.EE01.96.1