9330 Rmp and Irc

Embed Size (px)

Citation preview

  • 8/10/2019 9330 Rmp and Irc

    1/3

    LC IRC0002PW Powerware

    6/1/2004 8609 Six Forks Road

    Raleigh, NC 27615

    Industrial Relay Card Installation and Use

    Thank you for purchasing the Powerware Industrial Relay Card as an option for your

    Powerware UPS system. The Industrial Relay Card can be used to interface the RemoteMonitor Panel (Figure 3) to the UPS system, as well as provide four (4) isolated N/O or

    N/C relays for use to interface with facility monitors or equipment.

    Figure 1 (below) shows the installer what the card will look like, before installation into

    the UPS system. The wires shown in the picture are those, which would be installed wheninstalling a Remote Monitor Panel, which would give the user a remote indication of the

    status of the UPS system. The Remote Monitor uses a separate drive circuit, notassociated with the 250VAC rated relays, so both the Remote Monitor and isolated relayfeatures can be used at the same time. The isolated relay contacts are rated for 250VAC

    or 30VDC @ 5A (inductive or resistive load). Please review the following diagram forproper wiring terminations.

    Label as it appears on the board Alarm Battery Bypass Normal

    NO COM NC NO COM NC NO COM NC NO COM NC

    Remote Monitor

    Connection

    Strain Relief

    Grommet

    Relay

    Connections

  • 8/10/2019 9330 Rmp and Irc

    2/3

    LC IRC0002PW Powerware

    6/1/2004 8609 Six Forks Road

    Raleigh, NC 27615

    Figure 1After terminating the control wiring, the board is easily inserted in one of the

    communication bay slots on the back of the UPS system. These communication bays arenumbered from one (1) to four (4) with number one being the leftmost slot when looking

    at the back of the UPS system. This card needs to be installed in slots number one (1) or

    two (2) to ensure operation of the relays, consistent with the labels on the board. If thecard is installed in slots three (3) or four (4), the default setting would be similar to the

    contact closure conditions used with some computer systems, specifically those neededby IBM AS400 systems. Please refer to figure 2 below:

    Figure 2

    Included in your kit with your relay card will be a plastic strain relief grommet, which

    can be used to secure insulated multi conductor cabling with low signal voltages (

  • 8/10/2019 9330 Rmp and Irc

    3/3

    LC IRC0002PW Powerware

    6/1/2004 8609 Six Forks Road

    Raleigh, NC 27615

    Figure 3

    SpecificationsContact rating voltage: 250VAC, 30VDCContact rating current: 5 amps AC or DC

    Relays: 4 isolated single pole double throwConductor connectors: 6 position for remote display, 16-24AWG

    12 position for isolated contacts, 16-24AWGPower dissipation: 3.2W Max.External output power: Remote display power only

    300mA @~20VDC