Upload
jorgeroa111
View
2
Download
0
Embed Size (px)
DESCRIPTION
mec1
Citation preview
© 2008 Cummins Inc., Box 3005, Columbus, IN 47202-3005 U.S.A. Printed from QuickServe® Online.All Rights Reserved. Last Modified: 02-Mar-2011
File: 79-fc135 Page 1 of 2
Fault Code 135
Oil Pressure Sensor Circuit
CODES REASON EFFECT
Fault Code: 135PID(P), SID(S): P100SPN: 100FMI: 3Lamp: YellowSRT: 00-087
High voltage detected at oilpressure sensor signal pin 7 of thesensor harness connector.
No engine protection for oil pressure.
Oil Pressure Sensor Circuit
Circuit Description:The oil pressure sensor (OPS) is used by the electronic control module (ECM) to monitor the lubricating oil pressure.The ECM monitors the voltage on the signal pin and converts this to a pressure value. The oil pressure value is used bythe ECM for the engine protection system.
Component Location:M11 - The oil pressure sensor is located on the engine block to the right of the ECM.N14 - The oil pressure sensor is located on the engine block near the pan rail on the fuel pump side of the engine.
Shop Talk:Does the fault occur only in cold weather? If so, allow the oil to warm up and see if the fault goes inactive.
Refer to Troubleshooting Fault Code t05-135
© 2008 Cummins Inc., Box 3005, Columbus, IN 47202-3005 U.S.A. Printed from QuickServe® Online.All Rights Reserved. Last Modified: 02-Mar-2011
File: 79-fc135 Page 2 of 2