Test MethodValueUnitResin Properties

D123818g/10'Melt Index

D15050.952g/ccDensity

Test MethodValueUnitThermal Properties

D1525122CVicat Softening Point

Test MethodValueUnitMolded Properties

D7901350MpaFlectural Modulus

D256/A25J/mNotched Izod Impact @ 23 C

HD-52518 HDPE for Injection MoldingProductDescription52518 is a HDPE copolymer for injection molding for application requiring a good balance between easy of processability and flowability and mechanical properties.

TypicalApplicationHousewares, high fluidity

On compression molded according to ASTM D1928C

ProcessingConditionsRecommended barrel tempratures rang between 190 C and 280 C

JAM PETROCHEMICAL COMPANYP.O. Box : 75391415, Special Pars Economic Enegy Zone, Assalouyeh, Islamic Republic of IranTel: 0098 772 7323221Fax: 0098 772 7323311Customer Technical SupportTel: 0098 772 7323074Tel: 0098 21 88626490Fax: 0098 772 7323311Website: www.jpcomplex.com

Rev.0

10

100

1000

1 10 100 1000 10000

Viscosity

(Pa.s)

ShearRate(1/s)

Shear Viscosity@190C

StorageandHandlingPolyethylene products (in pelletized or powder form) should not be stored in direct sunshine and/or heat radiation. The Storage area should be dry and preferably don't exceed 50 C. JPC would not responsible about quality diminishing such as color change, bad smell or est. which caused by bad storage conditions. It is better to process PE resin within 6 months after delivery.

The technical information suggested uses and application presented are belived to be accurated and reliable, however JPC makes no warranties either express or implied concerning the information herein or the use of our materials.

Rev.0