Embed Size (px)
Citation preview
CX-S026-Channel 3D Flight USB RC Flight Simulator Cable
www.copterx.comCopyright © 2009 KY MODEL Company Limited.
INSTRUCTION MANUALINSTRUCTION MANUAL
01
MENUTable of content . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
1. Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2. Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
1
2
2
CX - S026-Channel 3D Flight USB RC Flight Simulator Cable
1. IntroductionThank you for purchasing the CopterX CX-S02 simulator cable. Now you are able to practice flying in the comfort of your living room in all weather conditions. Please follow the instruction below to setup your transmitter before you connect it to your simulator software.
1. Connect your tx to the T6config software.
2. It is hightly recommend you save your current setting in your computer so you can retrieve it later. Press “Save” and create a new file name as desire. Press “open” when finished.
2. Installation
02
CX - S026-Channel 3D Flight USB RC Flight Simulator Cable
3. Press “Type” and select “ACRO” then press “OK”
4. Press “EndPoint” and set all value to 120% then press “OK”
03
CX - S026-Channel 3D Flight USB RC Flight Simulator Cable
5. Press “Revserve” and donot select any of the check box then press “OK”
Now your transmitter is ready to hook up to the CopterX CX-S02 simulator cable.
1. With battery in transmitter, turn on transmitter and connect simulator cable to transmitter and computer.
Open fms2alpha83.exe
04
CX - S026-Channel 3D Flight USB RC Flight Simulator Cable
05
CX - S026-Channel 3D Flight USB RC Flight Simulator Cable
06
CX - S026-Channel 3D Flight USB RC Flight Simulator Cable
Connection with your computer
Select language
07
CX - S026-Channel 3D Flight USB RC Flight Simulator Cable
Interface setup and calibration
1. Choose Analog Control from the Controls menu2. Choose Joystick Interface in the pop-up window and click on
Mapping/Calibration, then OK
3. Input the data and tick the box as shown in the illustration.
4. Before clicking Next,please move the sticks in accordance to the pictures shown below
08
CX - S026-Channel 3D Flight USB RC Flight Simulator Cable
Setting the throttle trim down and center the rest of the trims.
Move the sticks several times in circle
Replace the sticks at the centre position
09
CX - S026-Channel 3D Flight USB RC Flight Simulator Cable
10
CX - S026-Channel 3D Flight USB RC Flight Simulator Cable
Select model type
Select model by clicking on Model and choosing Load
Load flying landscape
Select landscape by clicking on Landscape and choosing Load
Sound
Restart
Pause
www.copterx.comCopyright © 2009 KY MODEL Company Limited.
