Embed Size (px)
Citation preview
Revised January 14, 2004
BEFORE USING TEMPO PRODUCTS REFERENCE TO M.S.D.S. IS RECOMMENDED
IMPORTANT- The information contained in this data sheet pertains to material currently offered and represents the results of Laboratory evaluation and is intended as a guide. Since the customer’s application requirements are not under our control, Tempo Aerospace Inc. cannot make any warranties or guarantees for the results obtained.
TEMPO AEROSPACE INC. ISO 9001:2000 REGISTERED AIRCRAFT AND AUTOMOTIVE FINISHES 205 FENMAR DRIVE • TORONTO, ONTARIO CANADA M9L 2X4 TEL (416) 746-2233 • FAX (416) 746-2235 • E-mail [email protected]
SPECIFICATION DATA
4700- DURATHANE FLAT ENAMEL consists of: 4700- DURATHANE BASE and 4700-C-1 DURATHANE CATALYST
ALSO FOR: 7700 Line Spec.: CMS 565-02, BAMS 565-002, MIL-C-83286
DESCRIPTION Flat, hard, weather and chemical resistant aliphatic
polyurethane COLOUR Colours as specified
MIX RATIO 2 parts Base, 1 part Catalyst by volume
REDUCER THINNER 4600-S-72 (MIL-T-81772 Type I), suggest 10-15% (or 4600-S-1)
APPLICATION VISCOSITY Approx. 20 Seconds, #2 Zahn Cup
POT LIFE 8 Hours @ 25°C (77°F) at approximately 50% relative humidity
INDUCTION TIME 15 – 30 Minutes
RECOMMENDED FILM THICKNESS
1.5-2.0 mils dry
DRY TIME To tape 12 hours at 25°C (77°F), at approximately 50% relative humidity
APPLICATION Apply a light coat followed by a full wet coat to give a wet film thickness of 3-4 mils. May be applied by airless or conventional spray equipment
NOTE: CATALYST IS SENSITIVE TO MOISTURE AND MUST BE KEPT IN TIGHTLY CLOSED CONTAINERS. IF CATALYST TAKES ON A MILKY CAST IT SHOULD NOT BE USED AND SHOULD BE DISCARDED.
