Embed Size (px)
Citation preview
Technical Data and application
• Wima welded side seam: outside protective
•
•
•
•
•
Easy tapping by pressing the button
1. Lift the black tab and turn it into the direction shown by the arrow.
2. First of all – turn the top seal so that excess pressure is released slowly . Keep top seal open.
3. Turn the black spout according to the direction shown by the arrows on the spout.
4. Leave the top seal in an open position. Pull out the spout till it locks into stop position. Put two fingers behind the "T" of the spout and press the red button with your thumb to enjoy tapping a fresh beer! Beer flow will stop as soon as you release the red button.
Easy reclosing
1. Turn the black tab into closing position.
2. In case you want to keep some beer till the next day: Close the top seal again. Push back the spout into the party keg. Put the party keg back into the fridge.
B E V E R A G E I N N O V A T I O N S
5 Litre
stripcoated .
strong package.
coating.
• stackable units
(LFGB) and FDA.
systems.
process.
outstanding.
Technical Data and application
• Wima welded side seam: outside protective
•
•
•
•
•
stripcoate
strong package
coating.
• stackable units
(LFGB) and FDA.
systems.
process.
coating with laquer and inside specially powder
High pre-compression stability (min. 4 bar) due to the use of high quality tinplate.
Special inside lacquer meets food and beer specifi- cations (FDA) and keeps the beverage tasting fresh.
No matter what spout system is used, all closure and external tapping systems in the market fit this
100% pressure tested
• disinfected bottom ends, top ends and dustcap
Flanges and seams are lacquered with protective
The manufacture of the party keg underlies strong quality regulations. They are according to new techni -cal standards and fulfill the requirements of food laws
The keg may also be used for other liquid substances; an approval of the matching lacquer should be given in advance. For the filling of the party keg notable manufacturers o�er a wide variety of filling systems, ranging from manual up to high-speed automatic filling
A suitable closure for the top guarantees high tightness under pressure and good venting for an easy tapping
Because of the large surface area of the keg, it is ideal for advertising (on – premise brand visibility) in which matter we are able to assist you with our graphic studio and modern printing lines to make your product
Technical Data and application
• Wima welded side seam: outside protective coating with laquer and inside specially powder stripcoated .
• High pre-compression stability (min. 4 bar) due to the use of high quality tinplate. • Special inside lacquer meets food and beer specifi- cations (FDA) and keeps the beverage tasting fresh.
• No matter what spout system is used, all closure and external tapping systems in the market fit this strong package.
• 100% pressure tested
• disinfected bottom ends, top ends and dustcap
• Flanges and seams are lacquered with protective coating.
• stackable units
The manufacture of the party keg underlies strong quality regulations. They are according to new techni-cal standards and fulfill the requirements of food laws (LFGB) and FDA.
The keg may also be used for other liquid substances; an approval of the matching lacquer should be given in advance. For the filling of the party keg notable manufacturers a wide variety of filling systems, ranging from manual up to high-speed automatic filling systems.
A suitable closure for the top guarantees high tightness under pressure and good venting for an easy tapping process.
Because of the large surface area of the keg, it is ideal for advertising (on – premise brand visibility) in which matter we are able to assist you with our graphic studio and modern printing lines to make your product outstanding.
