Upload
doduong
View
228
Download
0
Embed Size (px)
Citation preview
3G+ MiFi GSM Router
Model No.: iB-W3GM072G
UserzManual
Ver.: 2.0.0
2
FCC STATEMENT
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/ TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received, including interference that
may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
FCC RF Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.
“To comply with FCC RF exposure compliance requirements, this grant is applicable to only Mobile Configurations. The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.”
3
CE Mark Warning
This is a class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures.
Safety Precautions
Read the safety precautions carefully to ensure the correct and safe use of your wireless
device.
Do not switch on your device when the device use is prohibited or when
the device use may cause interference or danger.
Follow the rules or regulations in hospitals and health care facilities.
Switch off your device near medical apparatus.
Switch off your device in an aircraft. The device may cause interference
to control signals of the aircraft.
Switch off your device near high-precision electronic devices. The
device may affect the performance of these devices.
Do not attempt to disassemble your device or its accessories. Only
qualified personnel are allowed to service or repair the device.
Do not place your device or its accessories in containers with strong
electromagnetic field.
Do not place magnetic storage media near your device. Radiation from
the device may erase the information stored on them.
Do not put your device in a high-temperature place or use it in a place
with flammable gas such as a gas station.
Keep your device and its accessories away from children. Do not allow
children to use your device without guidance.
Use approved batteries and chargers only to avoid explosion.
Observe the laws or regulations on device use. Respect others’ privacy
and legal rights when using your device.
4
Contents
Safety Precautions ........................................................................ 3
Package Contents ......................................................................... 5
1.Overview: ................................................................................... 5
1.2. Product Features………………………………………………….6
1.3. Introduction to MiFi GSM Router ............................................ 7
2. Access to the Internet ................................................................ 9
3.Login to the 3G+ MiFi GSM Router .......................................... 10
4. Access Router through USB cable .......................................... 10
5. Battery Usage Details .............................................................. 11
6. Restore to Factory Default ....................................................... 12
7. Multi Device Access through Router ........................................ 13
8. Appendix: Specification ........................................................... 14
Contact Information ............................................................ 15
5
Package Contents:
The following contents should be found in the product packaging:
3G+ MiFi GSM Router
Li-ion Battery
Universal Power Adapter
Brief introduction:
iB-W3GM072G is GSM Router to access Internet Anytime & Anywhere through 2G/3G
Internet.
Router as used for a long time in a enclosed space, the temperature of the device will
increase. Then it will turn off automatically. When this phenomenon appears, please put it
in ventilation space to dissipate the heat and when the temperature of the device
decrease, you can use it as normal.
• Please change default (SSID) and change password for wireless security purpose.
Conventions
The Router or device mentioned in this User Guide stands for iB-W3GM072G without any
explanations.
Parameters provided in the pictures are just references for setting up the product, which
may differ from the actual situation.
1. Overview
iBall Baton 3G+ MiFi GSM Router is compact size pocket / travel ideal for travel users.
2G/3G GSM Internet - Access Internet with mobility, Wi-Fi Ready - Personal Hotspot
Compact design with Li-ion battery ideal for Travel use
Mobile Hotspot with LED display to identify Network & Signal
6
1.1 Product Features:
Complies with IEEE802.11 b/g standards
Support 802.11n wireless connection
SIM slot GSM Router - 2G/3G Internet access
High Speed transmit rate upto 7.2Mbps HSDPA & 5.76Mbps HSUPA
2G/3G Frequency band HSPA / UMTS :2100Mhz
GSM/ GPRS/ EDGE: 850Mhz, 900Mhz, 1800Mhz & 1900Mhz
Internet sharing support up to 5 Wi-Fi users and 1 USB connection
32GB Micro SD card slot
With 1500mAH Li-ion battery
Working 4Hours , Standy time :16Hours
Charging Time: Max. 3 Hours (USB 5VDC, 750mAh)
SMS
Wireless security as WPA-PSK & WPA2-PSK
In-build DHCP Server
Internal Antenna
OS Compatible : WinXP, Vista, Win7, Win8 & MAC OS X10.5.0 up to 10.7.0
7
1.2 Introduction of 3G+ MiFi GSM Router
Device state
Item Status
Insert a SIM card No SIM card or SIM card falut
No service No Signal or SIM card fault
Internet Internet Connecting
No Internet Connection
WiFi
WiFi is Opened
Established WiFi Connection
WiFi is Closed
Message Unread messages
No unread message
Signal RSSI from weak to strong
Battery Level Battery Level from weak to strong
Charging
Boot charge from charging to saturation
Charge level from weak to strong with no booting
1.Reset Button
2.USB Interface
3.Power Button
4. iBall Baton Logo
5. Product Name
6.Total Internet Traffic Statistics
7.Identification of ISP
8.RSSI
9. Internet Access Type: 2G / 3G
10.WiFi
11. Internet : Connected / Disconnected
12.SMS Indication
13.Battery Level
14.Internet Connected Time Statistics
8
1.3 Install the SIM card, Micro SD card and battery
Make the card with corner side towards top left, then slide the card into slot.
System Requirements
CPU: Pentium 500MHz or above.
Hard Disk: 50MB available space.
Operating System: Windows 8/7/VISTA/XP (SP2 and above), Mac OS X 10.4.9 and
Later, Up to X10.6.0.
Display Resolving Power: 800 × 600 pixels or above (1024 × 768 is recommended).
Interface: Standard USB 2.0 interface.
Web Browser: Internet Explorer 6/7/8, Safari3/4/5.
One or more computing devices that support Wi-Fi (802.11b/g).
9
2. Access to the Internet
Description: By default, iB-W3GM072G has been complete pre-management
parameters, you can quickly access to the Internet by the following steps. As for the
detailed operation, please refer to the help information of “Management websites”.
Step I: ON / OFF of iB-W3GM072G
• Long press button for 3 seconds, then iB-W3GM072G is ON.
• Long press button for until it shows “Shutdown”, and then iB-W3GM072G is
OFF.
Note: Please don’t take out the battery directly to turn it off, you must long press
button until all indicator lights completely down, then you can take out the battery.
Step II: Establish a WiFi connection (Connect Computer for example)
1. Please make sure is ON.
2. Choose Start---- Control panel----Network
Connections---Wireless Network Connection.
Description: Before establishing a Wi-Fi connection,
you must ensure that the computer has been
equipped with a wireless card. If the computer
indicates the existence of wireless networks, then the
wireless card can be used. Otherwise, you need check whether the wireless card can
work.
3. Click to check the available wireless networks,
there will show the list of network connections.
4. Select the SSID which consistent with the
iB-W3GM072G and click .
Step III: Access to the internet
When the connection between user terminal and iB-W3GM072G is established, internet
will be available immediately.
10
3. Login to the 3G+ MiFi GSM Router
1. Confirm the connection for iB-W3GM072G with WiFi or the computer is good.
2. Open the browser, enter http://192.168.1.1 in the address field
3. Input username: admin and password: admin, then click “OK”.
Description: If you can't visit the management web page, please restart your
iB-W3GM072G and then you can visit without any issues.
11
4. Wired Connectivity through USB Cable
For Win 7/8/XP OS, driver will install automatically. Wait until driver installation over, you
could connect to Internet directly.
Note: It needs to install the driver in Windows XP SP3 systems, steps:
• Without SIM card. Under the Windows SP3 system, connect to computer via USB cable
connection, popup Window of the driver installation to install automatically, till “My
computer” popup and open it, copy the files of to the computer,
then shut iB-W3GM072G down.
• Open iB-W3GM072G when plugging the SIM card and wait for its identification , connect
to USB cable, then automatic pop-up RNDIS driver installation window,
choose click choose
click Choose 32bit or 64bit from folder ,Click
, click and then , then could surf internet。
5. Battery Usage Details
Charge battery
If the battery has not been used for a long time, please charge it to saturation state before
use.
• Use the matched USB cable to connect iB-W3GM072G with the computer, then the
charging icon on the screen shows the battery is charging.
• Using USB cable to charge battery in shutdown state, the charging icon will
automatically go out after it appears, If you want to open iB-W3GM072G, firstly to press
button to wake up iB-W3GM072G, then to long press button to open
iB-W3GM072G.
Note: If the battery runs out completely, then when you connect the USB cable to charge,
the screen will not show the charging icon. It needs to wait for about 1 minute before
charging icon appears for charging tips.
Power saving mode
Every 30 seconds iB-W3GM072G will be in the idle state. The screen light will be off. Then
in the state of idle, you just need to press button to wake iB-W3GM072G, the
screen light will be lighting all the time.
12
Installation of Micro SD card
1. Open the Micro SD card slot cover.
2. Input the Micro SD card.
3. Pin the SD card slot cover and push the cards then lock it in the slot.
6. Restore to Factory Default :
If you forget the SSID of the Router or the username and password of the Router, please
take the following methods to restore Wi-Fi default values:
Method I: RESET button
Press the RESET button for 3 seconds and then release it after the screen shows “Factory
default”, the screen will off.
Just wait for a moment, iB-W3GM072G will automatic restart. After restart the Router
will be in Factory Defaults Mode.
Method II: Plug and play function
• Directly connect to the computer, log in the administrator then you can view or change
the SSID’s username and password.
13
7. Multi-device access
High Speed download transmit rate up to 7.2Mbps Download & 5.76Mbps Upload
Access Internet through Wireless mobility to 5 Wi-Fi device.
Access Internet through wired USB connection
14
8. Appendix: Specification
Device Type WCDMA 3G Wireless Router
Network Type 3G:UMTS/HSDPA/HSUPA
2G:GSM/GPRS/EDGE
Frequency Band UMTS/HSDPA/HSUPA:2100MHz
GSM/GPRS/EDGE:850/900/1800/1900MHz
Data Transfer Rate Max7.2Mbps(DL)
Max5.76Mbps(UL)
Interface Micro USB
Memory Card Micro SD card support up to 32GB
Other Features SMS , Storage
Support System Windows & Mac 10.8.2*
Color White & Grey
Size 87*47*14.55mm
Weight 71g
Other parameters
Wi-Fi 802.11b/g
Support 5 Wi-Fi users
WPA-PSK encryption
Charging Charging interface:Micro USB 5V 750mA
Battery
Type:Detachable Li-ion battery
Capacity:3.7V/1500mAh
Standby time:16H(3G)
Working time:4H(3G)
Standard charging time:2.5H
15
COPYRIGHT & TRADEMARKS
Specifications are subject to change without notice. iBall Baton is a registered
trademark of Best IT World (India) Pvt. Ltd. Other brands and product names are
trademarks or registered trademarks of their respective holders.
No part of the specifications may be reproduced in any form or by any means or used
to make any derivative such as translation, transformation, or adaptation without
permission from Best IT World (India) Pvt. Ltd. All rights reserved.
Note: For any technical help on iBall Baton products please contact
www.iBallBaton.com | www.iBall.co.in