Intra-frequency measurement reporting criteria.The triggering
ofthe event-triggered reporting for anintra-frequency measurement.
All events concerningintrafrequency measurements are labelled 1x
where xis a, b, c.Event 1a:A Primary CPICH enters the Reporting
Range.Event 1b:A Primary CPICH leaves the Reporting Range.Event
1c:A Non-active Primary CPICH becomes better than an active Primary
CPICH.Event 1d:Change of best cell.Event 1e:A Primary CPICH becomes
better than anabsolute threshold.Event 1f:A Primary CPICH becomes
worse than anabsolute threshold.
Inter-frequency measurement reporting criteria.The triggering
ofthe event-triggered reporting for aninter-frequency measurements.
All eventsconcerninginterfrequency measurements are labelled 2x
wherex is a,b,c..Event 2a:Change of best frequency.Event 2b:The
estimated quality of the currently usedfrequency is below a certain
thresholdandtheestimated quality of a non-used frequency is abovea
certain threshold.Event 2c:The estimated quality of anon-used
frequency is above acertain thresholdEvent 2d:The estimated quality
of the currently usedfrequency is below a certain thresholdEvent
2e:The estimated quality of anon-used frequency is below a certain
thresholdEvent 2f:The estimated quality of the currently used
frequency isabove a certain thresholdInter-system measurement
reporting criteria.The triggering of the event-triggered reporting
for an inter-system measurement. All events concerninginter-system
measurements are labelled 3x where xis a,b,c..Event 3a:The
estimated quality of the currently usedUTRAN frequency is below a
certain thresholdandthe estimated quality of the other system
isabove a certain threshold.Event 3b:The estimated quality of other
system isbelow a certain thresholdEvent 3c:The estimated quality of
other system isabove a certain thresholdEvent 3d:Change of best
cell inother systemTraffic volume measurement reporting
criteria.Contains the measurement reporting criteria information
for atraffic volume measurement.Event 4a:RLC buffer payload exceeds
an absolute threshold.Event 4b:RLC buffer payload becomes smaller
than an absolutethreshold.UE internal measurement reporting
criteria.The triggering of the event-triggered reporting for a
UEinternal measurement. All events concerning UEinternal
measurements are labelled 6x where x is a, b, c. In TDD, the events
6a -6d are measured andreported on timeslot basis.Event 6a:The UE
Transmitted Power becomes larger than anabsolute thresholdEvent
6b:The UE Transmitted Power becomes less than anabsolute
thresholdEvent 6c:The UE Transmitted Power reaches its minimum
valueEvent 6d:The UE Transmitted Power reaches its maximum
valueEvent 6e:The UE RSSI reaches theUEs dynamic receiver
rangeEvent 6f:The UE Rx-Tx time difference for a RL included in the
active set becomes larger than an absolute thresholdEvent 6g:The UE
Rx-Tx time difference for aRL included in the active set becomes
lessthan an absolute threshold.
