Step 1Request for the surface.　 Choose a clean, dry，firm and even surface you are installing the panels on.

Step 2 Select a pattern for installation. Arrange it on the floor by rotating the panels before attempting to install ensuring correct installation of the desired pattern.

Step 3Use the Gradienter to measure and mark vertically and horizontally the area of installation, and use the pencil to mark the line.

Installation InstructionsTools needed:Wallpaper cutter, Tape measure, Gradienter, Ruler, Pencil, Sand paper (200 to 400Mu), Hammer, brush or spray gun, multifounctional glue, primer coat primer

Step 4Use the multifunctional glue to cover the area of installation. And roll, spray or brush on a generous coat of adhesive on the entire back of each panel. Allow adhesive to dry (following adhesive manufactures instructions)，and then Stick panels to the wall from the middle to the side according to the line marked by the pencil. Apply panels to surface pressing each panels firmly making sure that all corners are in contact with the surface. Also can use the hammer to make the corner firm.

Step 5Between each panels keep the distance as 2mm. Fill the gap with joint mixture or gypsum (PH in the middle). After the joint mixture absolutely dries, rub the gap down with sandpaper.

Step 6 Painting （Optional）• Using the interior wall elastomeric coatings (the percentage of elongtation must above 200%, and need not add water),• Paint can be brushed, rolled or sprayed on. Allow all coats to dry before applying subsequent coats. At least paint three times. The thickness for the coating must be above 40 micron.

Notice：The paint also can be other type depends on the features e.g. water-based paints and oil-based paints, etc.

www.3dwallpanel.net

R