3) Basic Wiring Diagram(ON/OFF for Single Speed)

•Signal Wires must be capped separately

•No Modules will function when fan is switched off

2) Automatic Control Wiring Diagram(Wire direct to power supply)•Signal Wires must be capped separately•Must have Motion or Condensation module for Fan to Operate in High Speed

•DO NOT connect Signal Wires to Power

1) Manual Control Wiring Diagram(ON/OFF or Boost from Low Speed to High Speed)

•Connect red Signal Wires directly to Wall Switch•All modules are functional when installed

• DO NOT connect Signal Wires to Power

WhisperGreen Select Wiring Configurations

Fan

WIRING METHOD 3 – For On/Off Operation Only (No plug in modules)

NOTE: This wiring method may cause Plug & Play modules to not function correctly. Red wires must be capped separately

Power

Power

WIRING METHOD 2 – For AUTOMATIC CONTROL only (All Plug & Play Modules)

NOTE: This wiring method is for AUTOMATIC CONTROL of the fan (motion sensor/humidity control ONLY). No manual control. Red wires must be capped separately.

Fan

Power

Fan

WIRING METHOD 1 – For MANUAL CONTROL & All Plug & Play modules

NOTE: This wiring method for MANUAL CONTROL of the fan. Red wires loop to Single Pole switch.