+12V Constant = BLUE/YELLOW

+12v Acc. Switched = GRAY

-12V Chassis Ground = BROWN

+12V Illumination = GREEN

+12V Dimmer =N/A

Amp Remote =

LF+ = PINK

LF- = PURPLE

RF+ = LT. GREEN

RF- = BLUE

LR+ =BLACK

LR- = YELLOW

RR+= RED

Dash Type :

Kit:Harness:Antenna Adapter: STD-MA

Interface Adapter(s): N/A

About the Vehicle

Make: TOYOTA

Model: TACOMA

Year: 2005

In Dash Application

Wire Color Codes

Speaker Notes

Front Speaker Sizes

Speaker Adapter : SAT6.Factory Assembly: Factory speaker is built onto factoryadapter.

Rear

TACOMATOYOTA

2005

DOUBLE DIN

TBA

TA-02B

RR- = WHITE

Factory Assembly : Factory speaker is built onto factoryadapter.

NOTES When installing aftermarket 5 ¼" or 6 ½" a speaker adapter is needed.

Lower Door : 6 1/2" Midrange

Speaker Sizes

Dimensions:

Factory speaker is built into speaker adapter

When installing aftermarket 5 ¼" or 6 ½" a speaker adapter is needed

Dimensions: W= L= D=

NOTES

Rear Door : 6 1/2"Midbass Speaker adapter: SAT6

OPTIONS

JBL SYSTEM6 DISC IN-DASH

AMPLIFIER LOCATIONS:

Aftermarket Kit: SINGLE DIN

W=L=D=

Upper Door: 3'' Tweeter

TOYOTA2005 TACOMA

Images

Front speaker

Rear speaker

Rear Speaker

1. Remove "A" panel on top of door panel.2. Extract (1) Phillip head screw from door release handle.3. Remove arm rest cover and extract (2) phillip head screws from behind it.4. Remove (1) push tab at top of inner door by the side mirror.5. Using a panel removal tool remove the door panel.6. Extract (3) 10mm bolts securing the speaker to the door. Disconnect and remove

"2 DOOR HAS NO BACK SPEAKERS." EXTENDED CAB1. Remove 1 phillips head screw from door handle. Remove handle cover.2. Remove 1 phillips head screw from arm rest pocket.3. Remove 1 pop tab at the top of the door panel.4. Remove 1 15mm bolt securing seat belt to bottom of the door.5. Using a panel removal tool remove the door panel.6. Extract 3 10mm bolts securing speaker to the door. Disconnect and remove. CREW CAB (4-DOOR) 1. Remove 1 phillips head screw from the door release handle.2. Remove 1 phillips head screw from arm rest pocket.3. Remove trim panel on rear side of the window.4. Remove 1 push tab just below the trim panel that you had just removed.5. Using a panel removal tool remove the door panel. Disconnect all plugs.6. Extract 3 10mm bolts securing speaker to

Radio removal

Front speaker

Rear speaker

1. Using a PRT carefully pry out the a/c controls.2. Remove (4) 10mm bolts securing the radio to the dash. Disconnect and remove