Upload
others
View
3
Download
0
Embed Size (px)
Citation preview
+12V Constant = LT. BLUE
+12v Acc. Switched = GRAY
-12V Chassis Ground = BROWN
+12V Illumination = DRK. GREEN
+12V Dimmer =
Amp Remote =
LF+ =
LF- =
RF+ =
RF- =
LR+ =
LR- =
RR+=
Dash Type :
Kit:Harness:Antenna Adapter: STD-ADT
Interface Adapter(s): N/A
About the Vehicle
Make: TOYOTA
Model: PRIUS
Year: 2005
In Dash Application
Wire Color Codes
Speaker Notes
Front Speaker Sizes
Factory Assembly: Plastic housing with (3) rivets.
Rear
PRIUSTOYOTA
2005
DIN AND A HALF
TBA
TBA
RR- =
Factory Assembly : Plastic housing with (3) rivets.
NOTES
Speaker Sizes
Dimensions:
Removing factory radio will no longer allow you to use some factory features. This includes the Climate control, Navigation, And factory JBL system. Other features may also be affected.
Dimensions: W= 5-5/8'' L= 5-5/8''D= 4-1/2''
NOTES
Rear Door: 1" tweeter Lower door: 6 ½ "Speaker Adapter: SAT6
OPTIONS
6 DISC CHANGERJBL PREMIUM SYSTEMDVD ONSTARBLUETOOTH
AMPLIFIER LOCATIONS: Located under passenger seat.
Aftermarket Kit: SINGLE DIN
W=L= D=
Center dash: 3" center channelMirror Pillar: 1" tweetersLower Door: 6 ½ " midrangeSpeaker Adapter: SAT6
TOYOTA2005 PRIUS
Images
Front Speaker
Tweet
1. Using a PRT unsnap inside mirror bezel, lift away disconnect and remove.2. Using a PRT unsnap door release cup inner panel, and extract (1) PHS from behind.3. Extract (1) PHS from door handle, lift away and remove.4. Using PRT unsnap the parimeter of door panel. Lift away, disconnect, and remove.
1. Unsnap (4) fastening clips securing speaker grill to dash bezel.2. Extract (2) PHS securing speaker to grill.
1. Using a PRT unsnap door release cup inner panel, and extract (1) PHS from behind.2. Extract (1) PHS from door handle, lift away and remove.3. Using PRT unsnap the parimeter of door panel. Lift away, disconnect, and remove.4. Extract (4) PHS to remove factory speaker from speaker adapter.
Radio removal
Front speaker
Rear speaker
1. Unsnap vent bezzel on right side of Radio.2. Unsnap vent bezel located on left side of steering wheel, and extract (1) PHS from behind.3. Extract (1) PHS from the panel directly under steering column. Unsnap lower steering column panel lift away disconnect and remove.4. Unsnap power button panel located above steering wheel, lift away, disconnect and remove.5. Unsnap vent bezel located on the left side of the Radio, lift away, disconnect and remove.6. Extract (2) PHS securing pocket trim bezel.7. Extract (2) 10mm hex bolts securing factory screen. Unsnap disconnect and remove
1. Using PRT pry off the plastic housing around the inside mirror pillar.2. Disconnect and remove.
Tweeter Removal
Radio
Rear Speakers
Front Dash