Linde Service Training

Procedure for performing

automatic calibration on the APC

200 transmission controller

For the TE 27 transmission

Linde Service Training

when the vehicle is built at the OEM

after each 2000 hours driving in gear

(forward or reverse selected).

when an overhaul of the transmission is

done.

when the transmission is repaired.

when the APC200 is replaced.

When the driver complains about bad gear

shift quality

A Calibration has to be done when :

Linde Service Training

APC200

SPICER OFF-HIGHWAY

E

D

F

M

S

On the APC 200 we have a 4 digit graph display, 3

LEDs and to Buttons to select different functions

The LED lamp labelled 'D' is yellow and is used to

indicate test modes.

The LED lamp labelled 'E' is yellow and is used to

indicate faults.

The LED lamp labelled 'F' is red and is switched on

when the APC200 is in the reset condition.

The M button is selecting the different display

modes/ function groups

See the description of the APC 200

The S button is scrolling in the different Display

modes / function groups

Linde Service Training

How to do the CALIBRATION

To enter into the calibration mode

Start the engine,press and hold the

S button for 15 seconds

M

S

Linde Service Training

To start the calibration,

press the button

S again

The engine starts

The display shows

tran

S

M

Linde Service Training

The display changs to

Go F

Now select on the gear lever

FORWARD

The Calibration is now

running in automatic mode

The display will show the

different stages !

Linde Service Training

Linde Service Training

When the calibration is done

the display shows up

Now , stop the engine and

the new calibration will be

saved in the APC 200

The machine is ready for

work again